Furniture of America California CM7558Q User manual

1. Insert 2 hanger bolts (#A) into the holes along each side of the
headboard (#1) and footboard (#2). Turn right to tighten.
2. Place the rails (#3)
onto the hanger bolts
(#A). Then apply a
hex nut (#B) onto the
ends from within the
rails. Secure using
the wrench (#D).
Insert the threaded ends of the support
legs (#5) into the holes along the slats
(#4). Turn right to tighten. Adjust the
leveler according to the ground level.

Place the slats (#4) onto the
rails (#3), then insert a wood
screw (#C) into each end and
secure using a Phillips screwdriver.

1. Insert 2 hanger bolts (#A) into the holes along each side of the
headboard (#1) and footboard (#2). Turn right to tighten.
2. Place the rails (#3)
onto the hanger bolts
(#A). Then apply a
hex nut (#B) onto the
ends from within the
rails. Secure using
the wrench (#D).
Insert the threaded ends of the support
legs (#5) into the holes along the slats
(#4). Turn right to tighten. Adjust the
leveler according to the ground level.

Place the slats (#4) onto the
rails (#3), then insert a wood
screw (#C) into each end and
secure using a Phillips screwdriver.

1. Insert 2 hanger bolts (#A) into the holes along each side of the
headboard (#1) and footboard (#2). Turn right to tighten.
2. Place the rails (#3)
onto the hanger bolts
(#A). Then apply a
hex nut (#B) onto the
ends from within the
rails. Secure using
the wrench (#D).
Insert the threaded ends of the support
legs (#5) into the holes along the slats
(#4). Turn right to tighten. Adjust the
leveler according to the ground level.

Place the slats (#4) onto the
rails (#3), then insert a wood
screw (#C) into each end and
secure using a Phillips screwdriver.