Furniture of America California CMBK588TEX User manual

1. Align the ends of the lower front side
rail (#5) and the lower back side rail (#6)
to the pre-drilled holes along the sides
of the lower end guardrail (#1,2).
2. Insert the barrel nuts (#C),
use a screwdriver to align
the hole for the bolt.
3. Insert the bolt (#A) into the pre-
drilled holes along the side and
into the barrel nut (#C). Secure
using the Allen wrench (#K). Make
sure to hold the barrel nut with a
screwdriver while securing the bolt.
Front
Back
1. Align the ends of the rail (#6) and
rail (#16) to the upper end guard
rails (#3,4). Insert the barrel nuts
(#C) into the rails, use a screwdriver
to align the hole for the bolt. Insert
the bolts (#A) into the pre-drilled
holes along the outer sides of (#3,4)
and into the barrel nut (#C). Secure
using the Allen wrench (#K). Make
sure to hold the barrel nut with a
screwdriver while securing the bolt.
Do not tighten bolts/screws
until they are all installed.
#B
2. Insert a wood dowel (#I) into
each end of the guard rails
(#17/18). Insert the other end
of the dowels into the holes
along the upper end guard rails
(#3/4), then insert a screw (#B)
into each end and secure using
the Allen wrench (#K).

1. Align a guard rail (#20)
to the pre-drilled holes
along the ends of the
front guard rails (#18)
and upper front side
rail (#16). Then insert
4 bolts (#E) and secure
using the Allen wrench.
#18
#16
2. Align a guard rail (#19) to the pre-
drilled holes along the center of the
rails. Insert 3 screws (#F) into each
guard rail (#19) and secure.
1. Insert a metal dowel
(#J) into the large pre-
drilled holes along the
top corners of the
bottom bunk.
2. With the help of another person,
carefully place the top bunk onto
those metal dowels (#J).

Align the top and bottom of the ladder (#7) to the pre-drilled
holes along the front rails. Insert a bolt (#D) into each end
from within the rails and secure using the Allen wrench (#K).
Apply the twin slat kit
(#9) onto the top bunk.
Insert a screw (#F) into
each end and secure
using a screwdriver.
Apply the full slat kit
(#8) onto the top bunk.
Insert a screw (#F) into
each end and secure
using a screwdriver.

1. Place the front panel
(#10) face down.
2. Insert a wood dowel (#H)
into the pre-drilled holes
along the corners of the
front panel (#10).
3. Place the right side
(#12) and left side
(#11) onto the other
end of those wood
dowels (#H).
Note: Right and left is determined
by facing the front of the front
panel (#10) in its upright position.
Insert 2 screws (#G) into
the holes along the sides
of (#11/12). Secure using
a Phillips screwdriver.

Align the bottom panel (#14) to the ridges
along the sides and carefully slide in.
Place the back panel (#13) and insert
2 screws (#G) into each end. Secure
using a Phillips screwdriver.