Furniture of America Luminar CM3559SV User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3559SV
Assembly Instructions
Tools Required for Assembly:
Rev.14-02-24
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
Phillips Screwdriver
(Not Included)

Page 2 of 5

Parts List
#1 x 1 pc
Server
#2 x 1 pc
Table Glass
#3 x 2 pcs
Glass Shelf
#A x 8 pcs
Shelf Support
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Due to the size and weight of this product, it is highly
recommended that the assembly should be done near
the area of its intended location. Make sure you
have enough space to move around during the
assembly. ALWAYS have at least two people to help
with transporting and assembling the product and to
avoid any potential injury and/or damage, especially
with the fragile nature of the glass.
MD
Page 3 of 5

Step 1 Due to the fragile nature of the glass, take caution when inserting the
table glass (#2) onto the top of the server (#1).
Step 2
Page 4 of 5
Insert 4 shelf supports (#A) onto the desired holes for
each side of the server (#1).
#A x 8 pcs
#1
Enlarged

Page 5 of 5
Step 4 To install the batteries (not included), remove
the screw that holds the battery cover by using
a Phillips screwdriver. Install new AA-size 1.5-
volt alkaline batteries with correct polarity (,)
following the illustration inside the battery cover.
Close the battery cover and tighten back the
screw.
Step 3
Turn right (clockwise) to tighten
Tilt the glass shelf (#3) at an angle and gently have it
rested and leveled on top of all 4 of the shelf
supports. Repeat the process for the other side.
Caution:
Use only batteries of the same type.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
Do not use rechargeable batteries.
Do not try to recharge non-rechargeable batteries.
Remove exhausted or corroded batteries.
Remove batteries to extend their life and to prevent
corrosion if the light is not be used for at least 2 weeks. Enlarged