Furniture of America CM-AC114 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-04-01
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
CM-AC114

Page 2 of 5

Parts List Hardware List
#1 x 1 pc
Table Top
#2 x 1 pc
Drawer Assembly
#3 x 4 pcs
Leg
#A x 8 pcs
Bolt 1/4”x2”
#B x 8 pcs
Bolt 1/4”x3/4”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 16 pcs
Lock Washer
MD
#D x 16 pcs
Flat Washer
Page 3 of 5
#E x 4 pcs
Bracket
#F x 1 pc
Allen Wrench

Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
Page 4 of 5
#B x 4 pcs
#C x 4 pcs
#D x 4 pcs
#E x 4 pcs
#B x 4 pcs
#C x 4 pcs
#D x 4 pcs
I. Carefully place the table top (#1) facing down on a protected surface.
II. Align the legs with the pre-drilled holes on the bottom of the table top (#1).
III. Prepare 4 bolt assemblies by inserting FIRST the lock washer (#C) onto the
bolt (#B) and then the flat washer (#D) onto the SAME bolt (#B), in that order.
IV. Insert the bolt assemblies through the brackets (#E) of the legs (#3) and
secure those bolts using the Allen wrench (#F) to lock them in with the table
top (#1).
Enlarged
I. Align the brackets (#E) with the pre-drilled holes on the legs (#3).
II. Prepare 4 bolt assemblies by inserting FIRST the lock washer (#C) onto the
bolt (#B) and then the flat washer (#D) onto the SAME bolt (#B), in that
order.
III. Insert the bolt assemblies through the brackets (#E) and secure those bolts
using the Allen wrench (#F) to lock them in with the legs (#3).

Turn right (clockwise) to tighten
Page 5 of 5
#A x 8 pcs
#C x 8 pcs
#D x 8 pcs
Carefully turn the completed table upright. Insert the drawers into the
drawer assembly (#2). Make sure the table is rested on a flat surface
and it does not feel loose or wobbly. If it does, double check that the
bolts are secured and properly tighten.
I. Remove the drawers out of the drawer assembly (#2).
II. Align the drawer assembly (#2) with the pre-drilled holes of the legs (#3).
III. Prepare 8 bolt assemblies by inserting FIRST the lock washer (#C) onto the
bolt (#A) and then the flat washer (#D) onto the SAME bolt (#A), in that
order.
IV. Insert the bolt assemblies through the pre-drilled holes of the drawer
assembly (#2) and secure those bolts using the Allen wrench (#F) to lock
them in with the legs (#3).
ASSEMBLY IS COMPLETED
3