Furniture of America CM-AC6900 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM-AC6900
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-10-31
Page 1 of 5
DIFFICULT
ASSEMBLY RATING

Page 2 of 5

Parts List
#1 x 2 pcs
Leg Stand
#2 x 2 pcs
Upper Stand Support
#3 x 1 pc
Center Stand Support
#A x 4 pcs
Bolt 1/4”x5/8”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
MD
Page 3 of 5
Hardware List
#4 x 1 pc
Seat
#C x 1 pc
Allen Wrench
#B x 10 pcs
F/H Bolt 1/4”x5/8”

Page 4 of 5
#A x 4 pcs
Insert 4 bolts (#A) through the center
stand support (#3) and secure those bolts
using the Allen wrench (#C) to lock them
with the 2 leg stands (#1).
Turn right (clockwise) to tighten
Insert the center stand support (#2) onto the 2 leg stands (#1).

Page 5 of 5
I. Align the 2 upper stand
supports (#2) with the pre-
drilled holes of the assembled
leg stands (#1).
II. Insert 4 flat-head bolts (#B)
through the 2 upper stand
supports (#2) and secure
those flat-head bolts using the
Allen wrench (#C) to lock them
with the assembled leg stands
(#1).
I. Place the seat (#4) facing
down on a protected
surface.Align the
assembled upper stand
supports (#2) with the pre-
drilled holes on the bottom
of the seat (#4).
II. Insert 6 flat-head bolts (#B)
through the upper stand
supports (#2) and secure
those flat-head bolts using
the Allen wrench (#C) to
lock them with the seat
(#4).
III. Make sure the chair is
rested on a flat surface and
does not feel loose or
wobbly. If it does, double
check that the bolts/screws
are secured and properly
tightened.
#B x 4 pcs
#A x 4 pcs
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
ASSEMBLY IS COMPLETED