Furniture of America Petro CM-AC6261 User manual

Rev. 15-12-17

Handle

1. Align the bottom of the side panels
(#3) to the pre-drilled holes located
on the inner part of the base (#2).
Insert threaded ends
of levelers (#B) into
the pre-drilled holes
on the bottom of the
front door (#5) and
rear panel (#4), turn
right to tighten acco-
rding to ground level
2. Insert a total of 4 bolts (#A) into
the inner pre-drilled holes and
secure using a Phillips screwdriver.

Align the rear panel (#4) to the pre-drilled
holes located along the back sides of the
side panels (#3). From within, insert bolts
(#A). Secure using a Phillips screwdriver.
1. Align the front door
(#5) to the holes
along the front sides
of the side panels
(#3). From within,
insert the bolts (#A)
and secure using a
Phillips screwdriver.
2. Insert bolts (#C) into
the two ends of the
base (#2). Secure using
the Allen wrench (#F).

1. Place the top panel
(#1) on top.
2. Insert a total of 4
bolts (#A) from
beneath into the
holes along each
side of the top pa-
nel. Secure using
a screwdriver.
3. Insert 2 bolts (#C) into
the top holes on the
rear panel. Insert a
bracket (#H) onto one
of those bolts and
secure both with the
Allen wrench (#F).
3. Apply the shelves (#7).
1. Place the clothes rail
(#6) into the slots
located inside.
2. Prepare 2 bolts by
inserting a small flat
washer (#N) onto
the bolts (#D), then
align the handle (#L)
to the door. Insert a
bolt assembly into
each hole and secure
using a screwdriver.

THE PARTS ARE FOR

1. Determine exactly where you want to drill a hole and mark the spot(s). Be sure that you
hold the drill perpendicular to the wall so that the anchor will sit parallel. You should drill
a hole that is approximately the same size as the anchor bolt (#I) itself. Insert anchor.
Use girding (#J) to attach the
bracket on the wall and the
bracket on the rear panel.
A
SSEMBLY IS COMPLETED
2. Insert one end of the bracket (#H) onto the screw (#K) then
insert screw into the anchor. Secure using a Phillips screwdriver.