Furniture of America CM-BR6887 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM-BR6887
Assembly Instructions
Tools Required for Assembly:
Rev.14-02-25
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
Allen Wrench (Included)

Page 2 of 5

Parts List
#1 x 1 pc
Gas Lift Cylinder
#2 x 1 pc
Foot Rest Assembly
#3 x 1 pc
Base
#A x 4 pcs
Bolt M6x14
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
MD
Page 3 of 5
#4 x 1 pc
Seat
#5 x 1 pc
Base Ring
#B x 1 pc
Allen Wrench

Step 1
Step 2
Page 4 of 5
Align the 4 pre-drilled holes of the foot rest assembly (#2) with the 4 pre-
drilled holes on the bottom of the seat (#4). Insert the bolt (#A) through the
hole of the foot rest assembly and secure that bolt using the Allen wrench
(#B) to lock it in with the seat (#4). Repeat for the remaining 3 bolts.
#A x 4 pcs
Insert the base ring (#5) onto the top of the base (#3). Then insert
the gas lift cylinder (#1) onto the base ring (#5). Remove the
protective plastic sleeve on the end of the gas lift cylinder.
Turn right (clockwise) to tighten
Enlarged
#2
#4
#A
#B

Page 5 of 5
Step 4 Check to make sure all parts are secured, the bar stool
is stable and the up and down lift is working properly.
Step 3 Place the assembled footrest/seat assembly over the
top of the assembled gas lift cylinder/base assembly.