Furniture of America CM2706 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.15-02-04
Page 1 of 6
DIFFICULT
ASSEMBLY RATING
CM2706
2 PERSONS RECOMMENDED
Phillips Screwdriver (Not included)

Page 2 of 6

Parts List Hardware List
#1 x 1 pc
Sofa Seat
#2 x 2 pcs
Armrest
#3 x 2 pcs
Armrest Frame
#A x 20 pcs
Screw 5x30mm
#B x 8 pcs
Screw 5x15mm
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 6 pcs
Bolt 5x60mm
MD
#D x 1 pc
Allen Wrench
#4 x 2 pcs
Front Leg
Page 3 of 6
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly.ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.
#5 x 2 pcs
Rear Leg

Page 4 of 6
I. Align the 2 front legs (#4)
with the pre-drilled holes on
the corners of the sofa seat
(#1).
II. Insert 12 screws (#A)
through the 2 front legs (#4)
and secure those screws
using the Phillip screwdriver
to tighten.
III. Align the threaded end of
the 2 rear legs (#5) with the
pre-drilled holes on the
corners of the sofa seat (#1)
and tighten by hand until
secured and aligned with the
holes.
IV. Secure 8 screws (#A) into
the 2 rear legs (#5) using a
Phillips screwdriver to
tighten.
With the help of another person, carefully place the sofa seat (#1)
facing down on a protective surface. Remove the 2 front legs (#4)
and the 2 rear legs (#5) located inside the sofa seat (#1).
#A x 20 pcs
Turn right (clockwise) to tighten

Page 5 of 6
I. Align the armrest frame (#3) with the pre-drilled holes of the
armrest (#2).
II. Insert 4 screws (#B) through the armrest frame (#3) and
secure those screws using the Phillip screwdriver to tighten.
III. Repeat the process to assemble the other armrest frame (#3)
onto the other armrest (#2).
Turn right (clockwise) to tighten
#B x 8 pcs
#C x 6 pcs
I. Align the 2 assembled armrest frames (#3) with the pre-drilled
holes on the side of the sofa seat (#1).
II. Insert 6 bolts (#C) through the 2 armrest frames (#3) and
secure those bolts using the Allen wrench (#D) to lock them
with the sofa seat (#1).
Turn right (clockwise) to tighten
X 2

Page 6 of 6
ASSEMBLY IS COMPLETED
The sofa can be adjusted to become flat. Make sure the
retractable leg is extended out first and then lower the
backrest until it is flat with the seat.