Furniture of America CM-BK928TT User manual

Side Frame
Middle Frame
Rear

I. Align the lower bed rail (#4) to the pre-drilled holes
along the sides of the bed support tube (#3).
II. Insert 2 bolts (#C) into the pre-drilled holes on each
end and secure using the Allen wrench (#F). Repeat
process a second time.
Insert the upper end rail (#1) onto one set of bed support tubes.
Insert the upper end rail (#2) onto the other pair of bed support tubes.

Align the 2 bed side frames (#9) to the pre-drilled
holes on the ends and insert bolts (#A) into each
pre-drilled hole. Secure using the Allen wrench
(#F). Then align 2 middle frames (#10) to the pre-
drilled holes along the center and insert bolts (#A)
into each hole. Secure using the Allen wrench (#F).
I. Align the rear
connect bar (#7)
and the front
connect bar (#8)
to the bottom pre-
drilled holes along
the sides of the
lower bed rails.
Make sure they
match the upper
rail placements.
II. Align a spacer (#E)
to each end and insert
bolts (#D). Secure using
the Allen wrench (#F).
I. Align the top part of the front guardrail (#6)
and the rear guardrail (#5) to the top pre-
drilled holes on the upper end rails.
II. Insert a bolt (#B) into each end from within.
Secure using the Allen wrench (#F).
I. Align the front guardrail (#6) and the rear guardrail
(#5) to the corners of the upper end rails.
II. Align a spacer (#E) to each end and insert
bolts (#D). Secure using the Allen wrench (#F).

Align the ladder (#11) to the pre-drilled holes along the
opening of the front guardrail. Insert a bolt (#C) into
each end and secure using the Allen wrench (#F).
Make sure all parts are firmly secured.
ASSEMBLY IS COMPLETED