Furniture of America CM-AC120 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-03-18
Page 1 of 6
DIFFICULT
ASSEMBLY RATING
CM-AC120
Phillips Screwdriver (Not Included)

Page 2 of 6

Parts List Hardware List
#1 x 1 pc
Table Top
#2 x 4 pcs
Leg
#3 x 1 pc
Support Shelf
#A x 8 pcs
Bolt 1/4”x1-3/8”
#B x 8 pcs
Flat Washer
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Lock Washer
MD
#D x 1 pc
Allen Wrench
Page 3 of 6
#E x 4 pcs
Screw

Step 1
I. Carefully place the table top (#1)
facing down on a protective
surface. Align the leg (#2) with
the 2 pre-drilled holes onto the
table top (#1).
II. Prepare 2 bolt assemblies by
inserting a lock washer (#C) onto
the bolt (#A) and then the flat
washer (#B) onto the SAME bolt
(#A), in that order.
III. Insert two bolt assemblies
through the two pre-drilled holes
of the table top (#1) and secure
those bolts using the Allen
wrench (#D) to lock them in with
the leg (#2).
IV. Repeat the above process to
assemble the second leg (#2) but
on the opposite side of the first
leg.
Step 2
Turn right (clockwise) to tighten
Page 4 of 6
#A x 4 pcs
#B x 4 pcs
#C x 4pcs Enlarged
#1
Remove the drawer out of the table top (#1)
until assembly is completed.

Step 3
Step 4
Align and insert the support shelf (#3) with
the pre-drilled holes of the two legs (#2).
Turn right (clockwise) to tighten
Page 5 of 6
#A x 4 pcs
#B x 4 pcs
#C x 4 pcs
Enlarged
I. Align the third leg (#2) with the
pre-drilled holes onto the table
top (#1)AND the support shelf
(#3).
II. Prepare 2 bolt assemblies by
inserting a lock washer (#C)
onto the bolt (#A) and then the
flat washer (#B) onto the
SAME bolt (#A), in that order.
III. Insert two bolt assemblies
through the two pre-drilled
holes of the table top (#1) and
secure those bolts using the
Allen wrench (#D) to lock them
in with the leg (#2).
IV. Repeat the above process to
assemble the fourth leg (#2).

Step 5
Step 6
Insert 4 screws (#E) through the support shelf
(#3) and using a Phillips screwdriver to secure
the support shelf (#3) with the legs (#2).
Turn right (clockwise) to tighten
Page 6 of 6
#E x 4 pcs
Enlarged
ASSEMBLY IS COMPLETED
Carefully turn the completed table upright. Insert the
drawer back into the table top. Make sure the table is
rested on a flat surface and it does not feel loose or
wobbly. If it does, double check that the bolts are
secured and properly tighten.