Furniture of America CM3841T User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3841T
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-08-04
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED

Thank you for your purchase!
We hope you will enjoy your new product for many years to come. Our commitment
to providing quality products does not simply end when a purchase is made. We
stand behind our products and will provide any support needed in order for you to
fully enjoy your purchase. Your satisfaction is the greatest recognition we could
have.
Because we value your trust in our company, we will do our best to meet your
service expectations. Should you have any assembly related questions, parts
replacement requests, comments or suggestions, please feel free to contact us any
time. To help expedite the service, please have the assembly instructions available,
along with your order receipt.
[email protected]
www.foagroup.com
Toll-Free 1-888-980-5122 or 1-626-363-9311
1-626-270-4451
Monday to Friday 8:30 a.m. to 5:30 p.m. (PST)
https://twitter.com/foagroup
http://www.pinterest.com/foagroup/
http://instagram.com/foagroup#
https://www.youtube.com/user/FurnitureOfAmerica
Page 2 of 5

Page 3 of 5

Parts List
#1 x 1 pc
Table Top
#2 x 4 pcs
Leg
#A x 8 pcs
Bolt 5/16”x2”
#B x 8 pcs
Flat Washer
Before you begin, please read Page 3
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Lock Washer
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.
MD
Page 4 of 5
#D x 1 pc
Allen Wrench
Hardware List

I. With the help of another person, carefully place the table top (#1) facing down on
a protected surface.
II. Align the 4 legs (#2) with the bottom corners of the table top (#1).
III. Prepare 8 bolt assemblies by inserting FIRST the lock washer (#C) onto the bolt
(#A) and then the flat washer (#B) onto the SAME bolt (#A), in that order.
IV. Insert the bolt assemblies through the pre-drilled holes on the bottom corners of
the table top (#1) and secure those bolts using theAllen wrench (#D) to lock them
with the legs (#2).
V. Carefully turn the completed table upright. Make sure the table is rested on a flat
surface and does not feel loose or wobbly. If it does, double check that the bolts
are secured and properly tightened.
Turn right (clockwise) to tighten
Page 5 of 5
ASSEMBLY IS COMPLETED
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs