Furniture of America CM7070Q User manual

CM7070Q/F
Rev: 16-01-19

1. Prepare 6 bolt assemblies by first
inserting a lock washer (#B) onto
the bolt (#A) then a flat washer
(#C) onto that same bolt (#A).
2. Align the top of the headboard legs (#2 R/L) to the holes
along the sides of the headboard (#1), then insert 3 bolt
assemblies into each side. Secure using the Allen wrench.
Hook each end of the side
rails (#4) onto the slots along
the headboard legs (#2) and
the footboard panel (#3).

Prepare 3 bolt assemblies by inserting
a lock washer (#B) onto the bolt (#A).
Align the slat support legs (#6) to
the holes along the slats (#5), then
insert a bolt assembly from above.
Secure using the Allen wrench (#F).
Adjust according to ground level.
Align each end of the bed slats (#5) to the holes
along the side rails (#4), then insert a screw (#D)
into each end. Secure using a Phillips screwdriver.