Furniture of America CM-BK1049 User manual

WRONG
1) Attach the top holes of the upper panel (#5) and bottom
panel (#4) to the holes of the left and right back post (#2,3).
2) Prepare 4 bolts
assembly by inserting
flat washer (#G) onto
bolts (#A).Align the
bottom holes of the
upper panel (#5) and
bottom panel (#4) to the
holes of the left and right
back post (#2,3) Secure
with bolts (#A).

Right Side HB
Left
Side
HB
1) Prepare 11 bolts assembly by inserting flat washer (#11) onto bolts (#A). Align back
panel (#7) and front panel (#8) to the holes of the right and left side HB. Secure with
bolts (#A).
2) Align bottom back and front rails (#9,10)
to the bottom holes of the left and right side
HB. Secure with bolts (#A).
Prepare 24 bolts assembly by inserting flat washer (#G) onto bolts (#A). Align bed
base frame (#6) to the holes of the side rails. Secure with bolts (#A) as shown in
the picture.

1) Align ladder A (#11) to
the holes in-between the
bunk beds. Secure the top
ladder (#11) hole with Bolts
(#A) that contains lock
washer (#G).
2) Secure ladder holes (#11)
on the side of the left HB with
bolts (#B) that contains washer
(#G).
3) Secure ladder holes (#11) on the bottom
of side rails with bolts (#E) that contains
washer (#G).
1) Align upper panel (#5) to the top holes of the posts (#12,13).
Attach the upper panel (#5) top holes to the top holes of the
posts (#12,13).
2) Secure the bottom holes of the upper panel (#5) with
bolts (#A) that contains washer (#G).

Prepare 6 bolts assembly by inserting flat washer (#G)
onto bolts (#D). Align desk right and left frame
(#17,18) to the holes of the HB as shown in the picture.
Secure with bolts (#D).
HB
Prepare 4 bolts assembly by inserting flat washer
(#G) onto bolts (#A). Align rails (#19) to the holes
in-between the desk frames (#17,18). Secure with
bolts (#A).

Prepare 6 bolts assembly by inserting
flat washer (#G) onto bolts (#C). Align
top board (#21) to the holes of the desk.
Secure with bolts (#C).
1) Hook the bottom of holes of side
rails (#15,14) onto the bunk bed. Secure
with bolts (#D) that contains washer
(#G).
2) Secure top holes of the side rails (#15,14) onto
bunk bed with bolts (#D) that conrains washer (#G).
3) Secure rails to desk with bolts (#A) that
contains washer (#G).

Prepare 4 bolts assembly by inserting flat washer (#G) onto bolts (#D). Secure bottom holes,
where the side rails are resting on the desk, with bolts (#D).
Prepare 12 bolts assembly by inserting flat
washer (#G) onto bolts (#A). Place bed base
frame (#6) onto the bunk bed on top of desk.
Secure with bolts (#A).