Furniture of America CM7072Q User manual

1. Prepare 6 bolt assemblies by first
inserting a lock washer (#F) onto
the bolt (#C) then a flat washer
(#E) onto that same bolt (#C).
2. Align the legs (#2) to the
holes along the back of
the headboard (#1), then
insert 3 bolt assemblies
into each leg and secure.
Hook each end of the side rails (#4) onto the bolts along the headboard (#1)
and footboard (#3), then tighten the bolts using the Allen wrench (#H).

Place the ends of the drawer slat (#5) onto the slots along the rails,
then insert 2 screws (#B) into each end. Secure using a screwdriver.
Adjust according to
the ground level.
Align the drawer slat support (#6) to the hole along the bottom of the drawer slat
(#5), then insert the threaded end of the support stopper (#13) into that same hole
from above. Turn right to tighten and make sure both supports are firmly secured.

Align the end of the runners to the slat (#5), then insert
a screw (#A) into each end. Secure using a screwdriver.
Place the slats (#7) onto the rails, then align the
center slat (#10) to the holes along the bottom
of those slats (#7) and the slat supports (#9).
Insert a bolt (#D) from above and secure.

Place the bed slats (#8) onto the rails, then insert a
screw (#B) into each end. Secure using a screwdriver.
Place the slat cover (#12),
then insert the screws (#A)
and secure using a screwdriver.