Furniture of America Rexburg CM7382F User manual

& F
16-07-11

1. Prepare 8 bolt assemblies by first
inserting a lock washer (#B) onto
the bolt (#A) then a flat washer
(#C) onto that same bolt (#A).
2. Align the legs (#2) to the
holes along the side of
the headboard (#1), then
insert the bolts and secure.
3. Align each end
of the leg support
(#3) to the holes
along the sides,
then insert a bolt
assembly into each
hole. Secure using
the Allen wrench.
Hook each end of the side rails (#5) onto the slots
along the headboard (#1) and foot board (#4).

Insert the threaded ends of the support
legs (#7) into the holes along the center
rails (#6), turn right to tighten.
Adjust according
to the ground level.
Place the slats (#6) onto the side rails
(#5), then insert a screw (#E) into each
end. Secure using a screw driver.

1. Prepare 8 bolt assemblies by first
inserting a lock washer (#B) onto
the bolt (#A) then a flat washer
(#C) onto that same bolt (#A).
2. Align the legs (#2) to the
holes along the side of
the headboard (#1), then
insert the bolts and secure.
3. Align each end
of the leg support
(#3) to the holes
along the sides,
then insert a bolt
assembly into each
hole. Secure using
the Allen wrench.
Hook each end of the side
rails (#5) onto the slots
along the headboard (#1)
and foot board (#4).

Insert the threaded ends of the support
legs (#7) into the holes along the center
rails (#6), turn right to tighten.
Adjust according
to the ground level.
Place the slats (#6) onto the side rails (#5), then insert
a screw (#E) into each end. Secure using a screw driver.

1. Prepare 8 bolt assemblies by first
inserting a lock washer (#B) onto
the bolt (#A) then a flat washer
(#C) onto that same bolt (#A).
3. Align each end
of the leg support
(#3) to the holes
along the sides,
then insert a bolt
assembly into each
hole. Secure using
the Allen wrench.
2. Align the legs (#2) to the
holes along the side of
the headboard (#1), then
insert the bolts and secure.
Hook each end of the side rails (#5) onto the slots
along the headboard (#1) and foot board (#4).

Place the slats (#6) onto the side rails
(#5), then insert a screw (#E) into each
end. Secure using a screw driver.