Furniture of America CM7585Q User manual

Note: Left and right is
determined by facing the
front of the headboard
in its upright position.
1. Insert 2 dowels (#K) into each end
of the leg support (#3), then insert
the other ends into the left and
right headboard legs (#2).
2. Insert a bolt (#A) with lock washer (#C)
and flat washer (#D) into the inner holes.
Secure using the Allen wrench (#E).
1. Align the headboard (#1) to the holes
along the top of the headboard legs (#2).
2. Insert 3 bolts (#A) with lock washer (#C)
and flat washer (#D) into the holes along
each leg. Secure using the Allen wrench (#E).

1. Insert the threaded studs (#F) into the holes along the headboard
legs (#2), then place each end of the side rails (#6) onto those studs.
2. Apply a beveled washer (#H)
then a hex nut (#G) onto
each stud from within the
rails. Secure using the wrench.
Insert the threaded ends of the slat support legs (#8)
into the holes along the slats (#7), turn right to tighten.

Place the slats (#7) onto the
side rails (#6), then insert a
screw (#J) into each end.
Secure using a screwdriver.

1. Insert 2 dowels (#K) into each end
of the leg support (#3), then insert
the other ends into the left and
right headboard legs (#2).
2. Insert a bolt (#A) with lock washer (#C)
and flat washer (#D) into the inner holes.
Secure using the Allen wrench (#E).
1. Align the headboard (#1) to the holes
along the top of the headboard legs (#2).
2. Insert 3 bolts (#A) with lock washer (#C)
and flat washer (#D) into the holes along
each leg. Secure using the Allen wrench (#E).
Note: Left and right is
determined by facing the
front of the headboard
in its upright position.

1. Insert the threaded studs (#F) into the holes along the headboard
legs (#2), then place each end of the side rails (#6) onto those studs.
2. Apply a beveled washer (#H)
then a hex nut (#G) onto
each stud from within the
rails. Secure using the wrench.
Insert the threaded ends of the slat support legs (#8)
into the holes along the slats (#7), turn right to tighten.

Place the slats (#7) onto the
side rails (#6), then insert a
screw (#J) into each end.
Secure using a screwdriver.