Furniture of America CM7682Q User manual

I. Insert 1 wood dowel (#F) into the top pre-drilled holes on each end of the headboard (#1).
II. Align the right headboard leg (#2R) and left headboard leg (#2L) to the pre-drilled holes
on the ends of the headboard (#1).
III. Prepare 6 bolt assemblies by FIRST inserting the lock washer (#B) onto the bolt (#A) then
the flat washer (#C) onto that SAME bolt (#A), in that order. Secure using the Allen wrench (#D).
Hook the ends of the side rails (#4) into the designated slots along the
headboard legs and footboard (#3).

Insert the threaded ends of the slat support legs (#6) into the center pre-drilled holes on the
slats (#5). Tighten by hand.
Adjust the leveler according to the
ground level. To lower or to raise
the slat support leg, you need to
turn the leveler clockwise or
counterclockwise, respectively.
Align the ends of the slats (#5) to the pre-drilled holes along
the sides of the side rails (#4). Insert a wood screw (#E)
into each end and secure using a Phillips screwdriver.
ASSEMBLY IS COMPLETED

I. Insert 1 wood dowel (#F) into the top pre-drilled holes on each end of the headboard (#1).
II. Align the right headboard leg (#2R) and left headboard leg (#2L) to the pre-drilled holes
on the ends of the headboard (#1).
III. Prepare 6 bolt assemblies by FIRST inserting the lock washer (#B) onto the bolt (#A) then
the flat washer (#C) onto that SAME bolt (#A), in that order. Secure using the Allen wrench (#D).
Hook the ends of the side rails (#4) into the designated
slots along the headboard legs and footboard (#3).

Insert the threaded ends of the slat support legs (#6) into
the center pre-drilled holes on the slats (#5). Tighten by hand.
Adjust the leveler according to the
ground level. To lower or to raise
the slat support leg, you need to
turn the leveler clockwise or
counterclockwise, respectively.
Align the ends of the slats (#5)
to the pre-drilled holes along the
sides of the side rails (#4). Insert
a wood screw (#E) into each end
and secure using a Phillips
screwdriver.
ASSEMBLY IS COMPLETED

I. Insert 1 wood dowel (#F) into the top pre-drilled holes on each end of the headboard (#1).
II. Align the right headboard leg (#2R) and left headboard leg (#2L) to the pre-drilled holes
on the ends of the headboard (#1).
III. Prepare 6 bolt assemblies by FIRST inserting the lock washer (#B) onto the bolt (#A) then
the flat washer (#C) onto that SAME bolt (#A), in that order. Secure using the Allen wrench (#D).
Hook the ends of the side rails (#4) into the designated
slots along the headboard legs and footboard (#3).

Insert the threaded ends of the slat support legs (#6) into
the center pre-drilled holes on the slats (#5). Tighten by hand.
Adjust the leveler according to the
ground level. To lower or to raise
the slat support leg, you need to
turn the leveler clockwise or
counterclockwise, respectively.
Align the ends of the slats (#5)
to the pre-drilled holes along the
sides of the side rails (#4). Insert
a wood screw (#E) into each end
and secure using a Phillips
screwdriver.
ASSEMBLY IS COMPLETED