Furniture of America CM7930CK User manual

Assembly Instructions
ASSEMBLY RA TING Tools Required For Assembly:


 
 

 O O O@@o1FFICULT

(Included)
�
2 PERSONS RECOMMENDED
Page 1 of 6

  


BASIC ASSEMBLY TECHNIQUES
















C

















 

 

FAILURE TO FOLLOW THE GUIDELINES ABOVE MAY
RESULT IN INJURY AND/OR PROPERTY DAMAGE.
Page 2 of 6


J




 '

'/





 
 

Before you begin, please read Page 2
of "Assembly and Care Advice".
And remember, do not tighten until
each step is completed or instructed.
   

X 
  


X 
 0) 



   


   




  ;  



  @ 



 


Page 3 of 6





1. Insert an extension leg (#8) into
each end of the headboard (#1).
2. Once inserted, align a connecting plate (#E) to
the pre-drilled holes and insert 2 bolts (#A). Secure
using the Allen wrench (#F). Repeat on the other leg.
1. Insert the side rail (#3)
into the side rail (#4).
2. Prepare 3 bolts by
inserting a flat
washer (#D) onto
the bolts (#A).
3. Insert 2 bolt assemblies
into the bottom holes
and 1 into the side hole.
Secure the bolts using
the Allen wrench (#F).
4. Repeat the process for
a total of 2 side rails.

Prepare 2 slats (#5) and 2 slats (#6) by aligning a support
leg (#7) to the bottom then apply a flat washer (#D)
onto the bolt (#C) and insert that bolt assembly into
the top of the slat. Secure using the Allen wrench (#F).
1. Prepare a total of 8 bolt assemblies by inserting
a flat washer (#D) onto the bolts (#B).
2. Align the side rail (#4)
ends to the headboard
(#1) and the side rails
(#3) to the footboard
(#2). Insert 2 bolt
assemblies into each
end and secure using
the Allen wrench (#F).

1. Place the slats (#5) in the two
outer slots and the slats (#6)
in the two center slots.
2. Prepare 8 bolt assemblies by inserting
a flat washer (#D) onto the bolts
(#A). Then insert the bolt assemblies
into the side rails from below and
secure using the Allen wrench (#F).
ASSEMBLY IS COMPLETED