Furniture of America CM-BK623 User manual

2. Align each end of the upper head panel (#5) to
the holes along the posts, then insert a bolt (#H)
into each hole and secure using the Allen wrench.
1. Align and slide the lower head panel (#6) onto
the post, then insert the bolts (#H) into each
hole. Secure using the Allen wrench (#N).
2. Align each end of the upper head panel (#5) to the holes along the posts,
then insert a bolt (#H) into each hole and secure using the Allen wrench.
1. Align and slide the lower head panel (#6) onto
the post, then insert the bolts (#H) into each
hole. Secure using the Allen wrench (#N).

Align each end of the upper bed
frame (#9) to the holes along the
posts, then insert the bolts (#A)
with metal plates (#20) into
each. Secure using the Allen wrench.
1. Align the rear and front guard rails (#7,8) to the holes.
2. Insert the bolts (#H) into
the top holes and secure.
2. Insert the bolts (#E) with big washer (#L)
into the holes from beneath and secure.
4. Insert the bolt (#C) into the hole along the end,
then insert the nut (#K) into the other end. Secure.

Align the rear upper and lower tubes
to the holes along the posts, then insert
a bolt (#D) with washer (#L) into each
end. Secure using the Allen wrench (#N).
Align the back frame (#10)
to the holes along the rear,
then insert a bolt (#G) into
each hole and secure.

1. Insert the wheel (#26) into the slots along the left
seat (#13), then insert a bolt (#I) and a nut (#K). Secure.
Insert bolts (#H)
and secure.
3. Align the support tubes (#18)
to the holes, then insert the
bolts (#H) and secure.
2. Insert the threaded
ends of the spring
(#O) into the holes,
turn right to tighten.
3. Insert the threaded
ends of the spring
(#O) into the holes,
turn right to tighten.
2. Align the support tubes (#18)
to the holes, then insert the
bolts (#H) and secure.

Align the left and right seat (#13,14)
to the holes along the panels, then
insert the bolts (#B) and secure.
Place the back cushions (#15)
onto the panels, and secure.

Align the connect plate (#22) to
the holes along the bottom, the
insert the bolts (#H) and secure.

1. Align the support plate (#25) to the holes along
the desk panel (#17), then insert the bolts (#C)
and secure using the Allen wrench (#N).
2. Slide the desk panel (#17) into the slots.
3. Insert the bolts (#C) into
the holes and secure.
Align the extension tube
(#19) to the holes, then
insert the bolt (#I) and nut
(#J) into each hole. Secure.
2.

Align the ladder (#16) to
the guardrail, then insert
a bolt (#F) with washer (#L)
into each hole. Secure.