Furniture of America CM7946 User manual

Rev.15-04-02

I. Carefully place the left side rail (#1) on a protected surface. Align the headboard support A (#7) to the pre-drilled hole
on the left side rail (#1). Insert bolt (#C) and secure using the Allen wrench (#F).
II. Align a support leg (#14) to the other side of the left
side rail (#1). Insert bolt (#A) into the large pre-drilled
hole and bolt (#D) into the small pre-drilled hole.
Secure using the Allen wrench (#F).
III. Align a support leg (#14) to the other pre-drilled
hole on the left side rail (#1). Insert 2 bolts (#D)
and secure using the Allen wrench (#F).
I. Carefully place the right side rail (#2) on a protected surface.
Align the headboard support B (#8) to the pre-drilled hole on
the right side rail (#2). Insert bolt (#C) and secure using the
Allen wrench (#F).
II. Align a support leg (#14) to the other side of the right
side rail (#2). Insert bolt (#A) into the large pre-drilled
hole and bolt (#D) into the small pre-drilled hole.
Secure using the Allen wrench (#F).
III. Align a support leg (#14) to the other pre-
drilled hole on the right side rail (#2). Insert
2 bolts (#D) and secure using the Allen
wrench (#F).

Align a support leg (#14) to the pre-
drilled holes on the headboard
connect (#3). Insert 2 bolts (#D) and
secure using the Allen wrench (#F).
I. Align the headboard connect (#3) to the right/left side rails (#1,2).
II. Insert 2 bolts (#D) into each corner and secure using the Allen wrench (#F).

Insert 7 rails (#5) into the designated slots along
the sides of the right/left side rails (#1,2).
I. Align the headboard up connect (#9)
and headboard tube frame (#10) in
between the headboard supports A/B.
II. Insert 2 bolts (#C) to lock the headboard
up connect (#9) and use 4 bolts (#D) to
lock the headboard tube frame (#10).
Secure using the Allen wrench (#F).
I. Align the headboard frame (#11)
in between the headboard up tube
frame (#10) and headboard connect (#3).
II. Insert 2 bolts (#E) to the top and 2 bolts
(#A) to the bottom and secure using the
Allen wrench (#F).

I. Align the panel (#13) to the headboard up tube frame (#10) and the headboard (#12) to the headboard frame (#11).
II. Prepare 6 bolt assemblies by inserting a washer (#H) onto the screw (#G). Insert connect the panel (#13) and secure
using the Phillips screwdriver.
III. Insert 4 bolts (#C) to connect the headboard (#12) and secure using the Allen wrench (#F).
I. Align the footboard (#6) in between the left/right side rail.
II. From within, insert 2 bolts (#D) into each side and secure using the Allen wrench (#F).

I. Align the wheels (#15) to the left/right side rails.
II. On the other side insert 2 bolts (#B) into each
wheel and secure using the Allen wrench (#F).
Make sure all bolts are firmly secured.
ASSSEMBLY IS COMPLETED