Furniture of America Colman CM3615T-60 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3615T-60
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-10-22
Page 1 of 4
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
Phillips Screwdriver (Not Included)

Page 2 of 4

Parts List
#1 x 2 pcs
Leg Stand
#2 x 1 pc
Table Top
#3 x 2 pcs
Apron
#A x 20 pcs
Bolt 1/4”x5/8”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.
MD
Page 3 of 4
Hardware List
#4 x 1 pc
Leg Stand Support
#C x 1 pc
Allen Wrench
#B x 10 pcs
Screw

Page 4 of 4
I. With the help of another person,
carefully place the table top (#2)
facing down on a protected surface.
II. Align the assembled leg stands (#1)
with the pre-drilled holes on the table
top (#2).
III. Secure 6 screws (#B) through the 2
leg stands (#1) and 4 screws (#B)
through the 2 aprons (#3) using a
Phillips screwdriver to secure them
with the table top (#2).
IV. Carefully place the completed table
upright. Make sure the table is rested
on a flat surface and does not feel
loose or wobbly. If it does, double
check that the bolts/screws are
secured and properly tightened.
#A x 20 pcs
I. Align the 2 aprons (#3) with the
brackets of the leg stand (#1).
II. For each bracket of the leg stand
(#1), insert 2 bolts (#A) through the
bottom of the bracket and 2 bolts
(#A) through the side of the bracket
using the Allen wrench (#C) to
secure them with the apron (#3).
III. Align one end of the leg stand
support (#4) with the pre-drilled
holes on the center of the same leg
stand (#1).
IV. Insert 2 bolts (#A) through the
bracket of the leg stand support (#4)
using the Allen wrench (#C) to
secure them with the leg stand (#1).
V. Repeat the process above to
assemble the other leg stand (#1)
onto the other ends of the 2 aprons
(#3) and the leg stand support (#4). Turn right (clockwise) to tighten
ASSEMBLY IS COMPLETED
Turn right (clockwise) to tighten
#B x 10 pcs