Furniture of America CM-BN6017S User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM-BN6017S
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-06-19
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
Phillips Screwdriver
(Not Included)

Page 2 of 5

Parts List
#1 x 1 pc
Seat
#2 x 1 pc
Leg Support
#3 x 2 pcs
Leg
#D x 8 pcs
Flat Washer
#E x 8 pcs
Lock Washer
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#F x 4 pcs
Connector
MD
#G x 4 pcs
Connector Bolt
Page 3 of 5
#H x 4 pcs
Bracket
#I x 1 pc
Allen Wrench
Hardware List (Continued)
Hardware List
#A x 8 pcs
Bolt 5/16”x7/8”
#B x 8 pcs
Bolt 5/16”x7/8”
#C x 4 pcs
Connector Screw

I. Align the two brackets
(#H) with the pre-drilled
holes on the leg (#3).
II. Insert 4 bolts (#A) into
the bracket (#H) using
the Allen wrench (#I) to
lock with the leg (#3).
III. Repeat the process to
assemble the remaining
2 brackets (#H) onto the
other leg (#3).
Turn right (clockwise) to tighten
Page 4 of 5
#A x 8 pcs
#H x 4 pcs
Turn right (clockwise) to tighten
I. Align the 4 connector bolts
(#G) with the pre-drilled holes
of the legs (#3) and hand-
tighten until secured as
shown on the diagram. Make
sure the holes in the
connector bolts (#G) are
facing upward.
II. Insert 4 connectors (#F) into
the leg support (#2). Make
sure the side holes in the
connectors are facing
outward.
III. Align the leg support (#2) with
the connector bolts (#G)
assembled on the legs (#3).
IV. Tighten the connector screws
(#C) through the connectors
(#F)AND the connector bolts
(#G) using a Philips
screwdriver to secure them to
the leg support (#2).
#C x 4 pcs
#F x 4 pcs
#G x 4 pcs

I. Carefully place the seat (#1) facing down on a protected surface.
II. Align the brackets (#H) assembled onto the legs (#3) with the
pre-drilled holes on the bottom of the seat (#1).
III. Prepare 8 bolt assemblies by inserting FIRST the lock washer
(#E) onto the bolt (#B) and then the flat washer (#D) onto the
SAME bolt (#B), in that order.
IV. Insert those bolt assemblies through the brackets (#H) and
secure those bolts using the Allen wrench (#I) to lock them with
the seat (#1).
V. Carefully turn the bench upright. Make sure the bench is rested
on a flat surface and it does not feel loose or wobbly. If it does,
double check that the bolts/screws are secured and properly
tighten.
Page 5 of 5
Turn right (clockwise) to tighten
#B x 8 pcs
#D x 8 pcs
#E x 8 pcs
ASSEMBLY IS COMPLETED
#H