FW skyus 3g aeris User manual

Quick Start Guide
Aeris
TM
Skyus 3G

1
Skyus 3G Aeris Quick Start Guide
Preface
Copyright
© 2016 Feeney Wireless, LLC a Novatel Wireless Company. All rights reserved.
This document may not be copied in part or otherwise reproduced without prior written consent from Feeney
Wireless except where specifically permitted under US and International copyright law.
Disclaimer
The information in this document is subject to change without notice. Feeney Wireless (“FW”) assumes no
responsibility for inaccuracies or omissions and specifically disclaims any liabilities, losses, or risks, personal or
otherwise, incurred as a consequence, directly or indirectly, of the use or application of any of the contents of this
document. For the latest documentation, contact your local supplier or visit us online at www.feeneywireless.com.
This publication may contain examples of screen captures and reports used in daily operations. Examples may
include fictitious names or individuals and companies. Any similarity to names and addresses of actual businesses or
persons is entirely coincidental.
Trademarks and Patents
Feeney Wireless and the FW logo are trademarks of Feeney Wireless LLC. Skyus, Skyus 3G, Skyus 4G, Skyus Global,
CIRA, CIRA X, CIRA X2, and Axiom are trademarks of Feeney Wireless LLC. VaraSight and the VaraSight logo are
trademarks of Feeney Wireless LLC.
Other trade names used in this document may be trademarks or registered trademarks of the manufacturers or
vendors of the respective products.
Intended Use
Use this product only for the purpose it was designed for; refer to the datasheet and user documentation. For the
latest product information, visit us online at www.feeneywireless.com.
Document number: 25-52-002-09 (Revision B)

2
Skyus 3G Aeris Quick Start Guide
Contents
Overview .......................................................................................................................................................................................................................3
Intended Audience..............................................................................................................................................................................................3
Scope.........................................................................................................................................................................................................................3
Environmental Specifications..........................................................................................................................................................................3
Power Consumption ...........................................................................................................................................................................................3
LED States................................................................................................................................................................................................................4
Installation Steps........................................................................................................................................................................................................4
Packing List: Package Contents ......................................................................................................................................................................4
Operating Systems ..............................................................................................................................................................................................4
Installation of Sierra Wireless Driver...................................................................................................................................................................5
Connecting the Antenna ........................................................................................................................................................................................6
Connecting to Computer or Router ...................................................................................................................................................................6
Activation......................................................................................................................................................................................................................7
Provisioning.................................................................................................................................................................................................................7
Activating the Skyus 3G Aeris Using AT Commands..............................................................................................................................7
Connection Manager ...............................................................................................................................................................................................8
Skyus Watcher Utility..........................................................................................................................................................................................9
Sierra Wireless Skylight ......................................................................................................................................................................................9
Contacting FW ............................................................................................................................................................................................................9
Online Library .....................................................................................................................................................................................................10
Return and Warranty........................................................................................................................................................................................10
Further Specifications...................................................................................................................................................................................... 10
FCC Compliance......................................................................................................................................................................................................11

3
Skyus 3G Aeris Quick Start Guide
Overview
The Skyus platform is a rugged, low-cost, self-contained modem kit. The Skyus platform simplifies the integration
efforts of adding mobile connectivity in M2M solutions and accelerates time-to-market for creating connected
devices. In contrast to standalone radio modules, the Skyus uses a standard USB connection interface, making it
readily compatible with the largest choice of host devices.
Integration of the Skyus 3G into a Windows based system requires at a minimum two high level components, the
driver and a mechanism to provide connection management.This document is intended to guide you through the
process of connecting the hardware and setting up these two components.
Intended Audience
This document is intended for users responsible for the initial set-up of the Skyus and assumes the installer possesses
a basic working knowledge of computer networking, wireless routing and network administration.
Scope
This Quick Start Guide focuses on the installation and configuration of the Skyus.
FW recommends initial set-up of the Skyus should be performed on a bench with a computer to gain some
familiarity with the hardware and software of your system.
Environmental Specifications
The Skyus 3G is designed to operate in a minimum ambient environment of -30°C or -22°F.
The Skyus 3G is designed to operate in maximum ambient environment of 60°C or 140°F.
Power Consumption
The Skyus 3G power consumption is specified as: 500 mA at 5 VDC typical, 1 A peak.
Figure 1: Skyus Top View Figure 2: Skyus Ports
Indicator Light
Mini USB Port
SMA Antenna
Connectors

4
Skyus 3G Aeris Quick Start Guide
LED States
State Indicates
Off Module is not powered.
On Module is powered and connected, but not transmitting or receiving.
Slow Blink Module is powered and searching for a connection.
Fast Blink Module is transmitting or receiving
Note: MC572x modules support customer-defined LED controls.
Installation Steps
•Inspect the package contents and compare against the packing list.
•Install the Sierra Wireless Driver.
•Connect the antenna.
•Connect the Skyus to a computer or router.
•Verify activation.
•Install the connection manager.
•Verify a connection to the Internet.
Packing List: Package Contents
Item Description
Skyus Skyus 3G Device
Cable USB 2.0 Type A Male to Mini B Male
If, during inspection of package contents, you determined that you are missing an item, please contact your FW
Service Representative.
Figure 3: Package Contents: Skyus 3G Figure 4: Package Contents: USB 2.0 Type A Male to Mini B Male
Operating Systems
The information contained in this guide is focused on operating your device in a Windows environment. If your
system is operating with a non-Windows application, please contact FW for guidance that is specific to your
environment.

5
Skyus 3G Aeris Quick Start Guide
Installation of Sierra Wireless Driver
The Skyus 3G utilizes an internal Sierra Wireless radio module. Drivers for Windows based platforms are provided in
binary form by Sierra Wireless and are available for download on the FW website. For quick connection, download
the driver-only package directly from FW. This package is available here:
www.feeneywireless.com/downloads
Under ‘Skyus 3G Drivers’ click the ‘Download Files’ button to begin downloading the driver file for installation.
If you are working on the device you intend to use the Skyus with, proceed with installation on the local drive.
If you are working on a separate device from the one you intend to use the Skyus with, save the file to a portable
media device and install the drivers on the target device.
Begin the installation of the Sierra Wireless drivers by clicking on the executable driver installation file.
Figure 5: Sierra Wireless Driver Installation
Follow the necessary steps to finish the installation until the screenshot matches the image shown in Figure 6.

6
Skyus 3G Aeris Quick Start Guide
Figure 6: Sierra Wireless Installation Completed
Connecting the Antenna
To ensure that you are using the appropriate cellular antenna, please contact your FW representative to provide the
proper service to your installation.
Band: CDMA 1xRTT/EV-DO RevA 850/1900 MHz
Connect the cellular antenna to the outermost antenna connection of the Skyus, as shown in Figure 7. The innermost
antenna connection is primarily used for 4G devices. It is used for receive diversity and is optional.
Figure 7: 3G Antenna Connection
Connecting to Computer or Router
Connect the Type A Male side of the enclosed USB cable to your computer or alternate host device.
Connect the Mini B Male side of the enclosed USB cable to the Skyus.
Antenna Connection

7
Skyus 3G Aeris Quick Start Guide
Figure 8: Type A Male USB Figure 9: Type Mini B Male USB
Power is provided by the USB cable. Once connected, your Skyus will power up and attempt to register to the carrier.
Activation
Your device is ready to be activated only after the cellular carrier sets up an account and provides a phone number
and IP address for your device. Once you have an account associated with your device, activation will need to be
performed when connecting to the cellular network for the first time. If you are not sure if your device has an
account, contact your Aeris carrier representative or FW support.
Provisioning
Once your device is activated by Aeris and you are attempting to connect to Aeris’s network for the first time, your
device will need to be provisioned.
The provisioning process varies depending on which connection manager you are using.
NOTE: FW offers a provisioning service for this model Skyus. Check with your FW sales or support
representative to see if this provisioning process has already been performed on your Skyus device if you
are unsure.
Activating the Skyus 3G Aeris Using AT Commands
To activate the Skyus 3G Aeris using AT commands, you will need access to the AT command interface via a terminal
program such as HyperTerminal, PuTTY, or Tera Term (contact FW support if you need help using a terminal
program). The only settings you will need to program are the Mobile Identification Number (MIN) and Mobile
Directory Number (MDN). All other settings are preprogrammed and do not need to be modified. The MIN and MDN
are provided by your Aeris representative.
After the device is provisioned, enter the device parameters using the steps below, where:
XXXXXXXXXX = Device MDN
YYYYYYYYYY = Device MIN

8
Skyus 3G Aeris Quick Start Guide
1. Enter the Number Assignment Module (NAM) unlock code:
AT~NAMLCK=000000
Response: OK.
2. Program the MDN and MIN:
AT~NAMVAL=0,XXXXXXXXXX,YYYYYYYYYY
Response: OK.
3. Reset the module:
AT~RESET
Response: OK.
To validate the activation, follow the steps below. This procedure is optional.
1. Enter the NAM unlock code:
AT~NAMLCK=000000
Response: OK.
2. Confirm the MDN and MIN:
AT~NAMVAL?0
Response:
MDN: XXXXXXXXXX
MIN: YYYYYYYYYY
SID:
NID:
3. Confirm the Network Access Identifier (NAI) is <MDN>@tsp08.sprintpcs.com, and confirm HA-SPI is 23747:
AT$QCMIPGETP
Response: Profile 1 details.
Connection Manager
There are multiple options for connection management. The following sections provide a brief description of relevant
connection managers. Please contact FW Support for guidance regarding the correct manager for your installation.

9
Skyus 3G Aeris Quick Start Guide
Skyus Watcher Utility
FW Skyus Watcher is designed to manage the connection to the cellular network and provides connection
watchdog, connection status reporting, and logging functionality appropriate for M2M applications where 24x7
connectivity is desired.
Figure 10: Skyus Watcher Utility – User Interface
Skyus Watcher is available after signing an End User Licensing Agreement (EULA) with FW. Skyus Watcher can be
downloaded from the FW website. The Skyus Watcher installation package is available at:
www.feeneywireless.com/downloads
For information on the installation of the Skyus Watcher application, please refer to the “Skyus Watcher User Guide.”
Sierra Wireless Skylight
Sierra Wireless provides a connection utility compatible with Skyus devices that can manage connections and
display network coverage indication. For more information on Sierra Wireless Skylight go to www.sierrawireless.com
or contact your FW sales representative.
Contacting FW
For help with installing, operating, maintaining, and troubleshooting this product, refer to this document and any
other documentation provided.
If you still have questions, contact us during business hours:
Monday through Friday, excluding holidays, between 8 a.m. and 5 p.m. Pacific Time.