13 Lid of the water tank
14 Ground coffee measuring scoop
15 Pod filter adapter (specific types only)
16 Coffee pod filter (specific types only)
17 Seat for accessories
18 Seat for coffee measuring scoop
19 Hot water/steam knob
20 Classic milk frother (specific types only)
21 Power cord
22 Main switch (RI8437, RI8435, RI8433) with energy saving switch)
First installation
1Remove all packaging material from the machine.
2Place the machine on a table or worktop away from the tap, the sink and heat sources.
Note: Leave at least 15 cm of free space above, behind and on both sides of the machine (Fig. 2).
Preparing for use
1Remove the lid of the water tank and remove the water tank from the machine (Fig. 3).
2Rinse the water tank. Fill the water tank with fresh water up to the MAX indication (Fig. 4).
3Place the water tank back into the machine and push it downwards until the reference marks are
visible (Fig. 5).
4Place the lid of the water tank back onto the machine.
Circuit priming
When you use the machine for the first time, after dispensing steam or when the water tank is empty,
perform the following steps:
1Place a container under the milk frother and turn the hot water/steam knob anticlockwise (Fig. 6).
2Insert the mains plug into a wall socket.Set the main switch to 'I' to switch on the machine (Fig. 7).
-The power-on light lights up.
3Turn the selection knob to the coffee position (Fig. 8).
-Hot water comes out of the milk frother.
4When the water tank is empty, turn the selection knob back to the standby position (Fig. 9).
5Turn the hot water/steam knob clockwise. Remove the container (Fig. 10).
Manual rinsing cycle
1Rinse the water tank. Fill the water tank with fresh water up to the MAX indication (Fig. 4).
2Place the water tank back into the machine and push it downwards until the reference marks are
visible (Fig. 5).
3Place a container under the classic milk frother and turn the hot water/steam knob anticlockwise
(Fig. 6).
4Turn the selection knob to the coffee position (Fig. 8).
-Let the machine dispense water until the water tank is empty.
5Turn the selection knob back to standby position (Fig. 9).
6Fill the water tank with fresh water up to the MAX indication.
7Insert the pressurized filter holder into the brew unit from below (Fig. 11).
8Turn the filter holder from left to right as far as possible and release the filter holder grip. The
handle will automatically jump back to the left again (Fig. 12).
10 English
