Gardeners 8600603 User manual

1-800-876-5520 • gardeners.com
[e-mail]
8% of our profits go back to our communities.
Learn more at gardeners.com/FoRCE-FoR-GoOD
3. Slide the TIE DOWN SYSTEMS into the
slots on each POLE. NOTE: If you prefer,
the TIE DOWNS can be added to the upper
POLES during Step . Secure the ends of
the TIE DOWNS to prevent your PLANTER
from tipping over in high winds.
TIE DOWN
SYSTEM
POLE
water fill holes
G Rev /#
Vine Trellis for Gardener's Victory
Self-Watering Patio Planter
2. Slide the BASKET over the POLES and
back on top of the PLANTER. Press it
securely into place. NOTE: If the BASKET
doesn't have the CAPILLARY STRIP and
GROW BAG installed already, do that now
following the Patio Planter instructions.
BASKET
PLANTER
BASKET (Bottom)
Parts List
() POLES () TOP TRELLIS PANEL
() POLE CONNECTORS () BOTTOM TRELLIS PANEL
() CAPS () CONNECTING CLIPS
() TIE DOWN SYSTEMS
() HOOK & LOOP STRIPS
NOTE: These instructions refer to the BASKET, PLANTER, CAPILLARY STRIP and GROW BAG that are part
of the Victory Self-Watering Patio Planter (sold separately).
4. Mix  cup of fertilizer into  quarts of
potting mix and pre-moisten. Fill your
PLANTER to within " to " of the top
edge. NOTE: We recommend our Organic
Self-Watering Potting Mix, as well as a
slow-release granular fertilizer, such as our
All Purpose Fertilizer.
1. Remove the BASKET from your empty
PLANTER and insert two POLES into the
slots on the inside (smooth sides facing
towards the center of the PLANTER).
PLANTER
(without
basket)
POLES (smooth side
facing towards the center)
PLANTER
BASKET
POLE
the POLES should
look like this when
inserted correctly
NOTE: The POLES will slide ½" into the
slots in the PLANTER.
inside PLANTER
slot
tabs should be visible
when fully secure

TOP TRELLIS PANEL
BOTTOM TRELLIS PANEL
TRELLIS
HOOK & LOOP
STRIP
POLE
CONNECTING CLIPS
5. Slide the POLE CONNECTORS into
the tops of the POLES you inserted in
Step , then slide two POLES over the
CONNECTORS. Repeat to attach the
remaining POLE CONNECTORS and POLES
and place the CAPS on top.
CAP (hole
positioned
towards
outside of
planter)
POLE
CONNECTOR
POLES
POLES
FROM
STEP 2
Planting, Watering, and Care Tips
• Fill the reservoir through the water fill holes (shown in Step ). Check your soil
moisture regularly and fill as needed. This is especially important when your
plant starts to flower and set fruit. If the soil dries out, refill the reservoir and
water thoroughly from above to re-establish the wicking action. If you overfill the
reservoir, excess water will drain out through the side vents.
• If you do need to move your PLANTER, use two people to lift it by the base of the
PLANTER. Do not try to lift it by the BASKET or supports.
• We recommend adding  cup of fertilizer every - weeks. Gently rake the fertilizer
into the soil and then top-water to help disperse it.
• In hot zones, place the planter in a spot that gets afternoon shade.
7. Slide the hooked ends on the TOP
TRELLIS PANEL into the holes on the
CAPS.
CAP
TOP TRELLIS PANEL
6. Attach the bottom of the TOP TRELLIS
PANEL to the BOTTOM TRELLIS PANEL
using the CONNECTING CLIPS.
8. Secure the TRELLIS PANELS to the
POLES using the HOOK & LOOP STRIPS.