Garett GT20S User manual

User manual
MULTILANGUAGE
www.garett.eu
SmartWatch
Garett
GT20S

MULTILANGUAGE
Polski 16
Lietuvos 42
Magyar 55
Nederlands 68
Română 81
Slovenčina 94
INFO (EN/PL) 120
Český 29
English 3
Українська 107

English
SECURITY ISSUES
Before use, carefully read the user's manual and save it for later use. The
manufacturer is not responsible for any damage / injury caused by improper
use. Depending on the part of the Smartwatch, some functions may differ with
the functions described in the user manual.
It is forbidden to use the device if it is damaged.
Using this device near medical devices may disrupt their operation. Pay
special attention when using the smartwatch near medical devices,
such as pacemakers, hearing aids and other electronic medical
devices.
It is forbidden to throw equipment into the fire. There is a risk of battery
explosion and, as a consequence, life and health hazards.
The device should be protected against heat sources and direct
sunlight.
Do not immerse the device in water.
Do not dive in the device.
In the event of damage, take the device to an authorized service centre
for inspection / repair. Attempting to repair it yourself may lead to
damage to the device and will void the warranty.
Only clean the device with a soft, slightly damp cloth. Do not use
chemicals or detergents to clean this device.
IMPORTANT! Smartwatch is not a medical device. The Garett GT20S
smartwatch and Garett Activ application are not used for medical diagnosis,
treatment or as a preventive measure against disease or illness. Before
changing your sleep habits and physical activity, first consult your doctor.

1. Display of the watch
2. Screen on / off / off button
3. Sensors
4. Replaceable strap
PRODUCT DESCRIPTION
INSTALLATION
Place the watch on your wrist and adjust the length of the strap so that
the device strap is not loose.
OPERATION
Turn on / off
Note: Before first use, make sure that the smartwatch is connected to the
application. The watch will automatically synchronize the time and the
physical activity data will be saved correctly.
Touch and hold your finger on the main screen to display the change menu
of the watch face. Swiping the left / right finger to select the dial and then
confirm the selection "Ok".
Change the watch face
Press and hold the on / off button (2) to turn the device on. To turn off the
device, press and hold the on / off button for approx. 3 seconds.

3. Before the first use, the device should be charged for approx. 2 hours.
1. The Smartwatch is charged using the magnetic cable attached to the
device.
Note: The device should be stable when charging.
2. Connect the magnetic end of the cable to the contacts on the back of the
device. Then connect the other end of the cable to the USB port of your
computer or USB power adapter.
CHARGING
Smartwatch works with your smartphone using the Garett Activ application.
Before using, download this application from the Google Play Store or
AppStore and install it on your phone.
The application can be searched by entering the name "Garett Activ" in the
store search engine or by scanning the corresponding QR code presented
below.
BEFORE FIRST USE
iOS Android