Gas Clip Technologies Multi Gas Clip Infrared User manual

Battery Information
Low Battery Warning - With 20 minutes of run time left, the detector will
beep, ash and display “LOW BAT”. Notications will continue periodically until
the battery expires and the detector performs an automatic shutdown.
Charging - While charging, the battery icon will cycle and the detector will
display an approximate charge percentage. Full charge occurs in 4-6 hours.
For fastest charging, charge while detector is turned o.
Warning - DO NOT charge the detector in a combustible atmosphere.
Warning - DO NOT charge the detector in temperatures above 104°F (40°C)
or below 32°F (0°C).
Additional Questions?
For additional information on the Multi Gas Clip gas detector regarding
programing, bump testing, calibrating, etc. please refer to the Multi Gas Clip
User’s Manual. The manual, videos and other helpful information are available
for viewing or download at www.gascliptech.com.
Contact Information
Gas Clip Technologies, Inc.
305 W. FM 1382, Suite 540
Cedar Hill, TX 75104 USA
Phone: [phone]
Fax: [phone]
Toll Free: 1.877.525.0808
E-mail: [email protected]
Website: www.gascliptech.com
MGC QSG v2.02
Portable gas detectors you can count on
Portable gas detectors you can count on
Quick-Start Guide
Multi Gas Clip
Infrared Multi Gas Clip
Pellistor
A
S
S
E
M
B
L
E
D
I
N
U
S
A

READ FIRST BEFORE OPERATION
The Multi Gas Clip is a personal safety device designed to detect the presence
of hydrogen sulde (HS), carbon monoxide (CO), oxygen (O) and combustible
gases (LEL). Before operation, ensure that you have been properly trained on
the use of the detector and the appropriate actions to take in the event of an
alarm condition.
Turning On the Detector
To activate the detector, press and briey hold down the power/menu button.
Activation tone will sound. Once activated, the detector will begin to display
Gas Readings immediately. Each Gas Identier will show a chasing “0”for the
Gas Reading while it is stabilizing and self-testing. Once all Gas Identiers
have completed the warm up and stabilization sequence, < 65 seconds, the
detector is ready to detect all applicable gases. Display will show:
Turning O the Detector
Press and hold down the power/menu button until the“OFF”countdown is
complete. During the countdown, the detector will beep and ash 4 times
then turn o. Display will show:
Manually Calibrating the Detector
Continuously hold down the power/menu button through the“OFF”
countdown and the“CAL ” countdown that follows it. During these two
countdowns, the detector will beep and ash 8 times with a pause between
countdowns. Release the button when display shows“AUTO ZERO”. Display
then shows“APPLY GAS”. Snap on the MGC calibration cap connected to a
hose, regulator and gas cylinder and apply gas. Calibration is complete when
the next calibration due date is displayed and the detector goes into alarm.
Turn gas o and remove calibration cap from detector. Display will show:
When a Gas Reading (4) exceeds its alarm threshold, the detector will go into
visual, vibrating and audible alarm. On the display, the icon will appear
beside the Alarm Condition (1) and the associated Gas Identier (5) will ash
o and on continuously.
Warning - Users must familiarize themselves with the icons in both alarm
and non-alarm states.
Warning - If the display is missing icons, or cannot be clearly read,
discontinue use and contact Gas Clip Technologies.
Warning - The IR LEL sensor will not detect hydrogen (H) or acetylene
(CH) gases however, due to their cross-sensitive nature, the CO sensor will
go into alarm well below 10% LEL.
Display Components
Factory Default Alarms
Icon Description
1 Alarm Condition
2 Calibration/Test Mode
3 Battery Charge Level
4 Gas Readings
5 Gas Identiers
Sensor LOW HIGH TWA STEL
H2S10 ppm 15 ppm 10 ppm 15 ppm
CO 35 ppm 200 ppm 35 ppm 50 ppm
O219.5% 23.5%
LEL 10% 20%
Warning - Before each use,
check that all sensor and alarm
ports are clear of any debris or
obstructions
Stabilizing Fully operational
Note: Calibration can also be done using the Multi Gas Clip Dock.
5
4
12
3