GDP Research Miniguide User manual

Miniguide Settings Quick Reference
To change settings, turn on aid and hold button:
# Pulses/ Settings
Beeps
1 . . . 4 metre
2 . . . 2 metre
3 . . . 1 metre
4 . . . Half metre
5 . . . 8 metre
Advanced Settings
6 . . . 1 preset, default
7 . . . 2 presets
8 . . . 3 presets
9 . . . Chirp audio, default
10 . . . Sweep audio
11 . . . Vibration on when earplug in, default
12 . . . Vibration off when earplug in
13 . . . Disables remote switch, default
14 . . . Enables remote switch
15 . . . 4 metre gap finding
16 . . . 2 metre gap finding
17 . . . 1 metre gap finding
20 . . . Lock present settings

Enabling Advanced Settings
With the aid off, press and hold the button down for about 30
seconds (until the aid gives a final pulse/beep).
Advanced settings will remain enabled until the aid is reset.
Unlocking aid
Same method as for enabling advanced settings.
Alternatively reset the aid.
Resetting aid (to default settings)
Reverse battery until aid vibrates, then replace battery
correctly. Alternatively, remove battery for two minutes.
Note:
Only certain types of earphone plugs can be used when
the remote switch option is enabled.
Modes 15, 16 and 17 can only be selected as the second
or third preset.
More detailed instructions for the Miniguide
are available on the internet
( at www.gdp-research.com.au ) in large-print
format (for printing), html format (so it can be
used with screen readers) and in MP3 format
(so it can be used with IPODs etc.)