HOW TO
OPEMTE
YOUR DRYER
(continued)
End
Cycle
Signal
(on models so equipped)
For models DDE8500S and DDG8580S. This
signal operates with
any
cycle. The control can be
set anywhere between OFF
and
LOUD, depending
on the desired sound level. The signal will sound
just before the end of the cycle to remind you to
remove the
clothes.To
stop the signal while sounding,
turn the signal control to OFF or advance the Cycle
Selector to OFF.
For models DDE9655S~DG9685S and
DDE8505S~DG8585S.
This signal operates
with any cycle. Press pad to select. The signal
will sound just before the end of the cycle to
remind you to remove the clothes. To cancel the
signal while sounding, press the Reset Options pad.
This signal should always be used when drying
polyester knits or permanent press items which should
be removed as soon as the dryer stops to help prevent
setting of
writies.
Polyester
hits
& Permanent Press Drying Tips
● DO NOT
OVERLOAB
● REMOVE
CLOT~S
“
PLACE ON
WNGERS—
Garments being dried or
PROMPTLY-TO
help prevent
Permanent press
and
polyester
dewrinkled
should tumble freely. wrinkling, remove clothes from knit garments look best if placed
the dryer promptly at the end of on hangers after drying.
the drying cycles.
The Difference Between Automatic and Timed Drying
Automatic Drying (Electronic)
Automatic Drying.
When using
Timed Drying
When using
(on some models) the Automatic Cycles, the dryer the Timed Cycles, you select
When using the Automatic Cycles,
continually senses the temperature the number of minutes you wish
the
Electronic Sensor Control
of the
air
in the dryer drum. Wet the dryer to run and it turns off
system
continually senses the
laundry keeps this air cool. When at the end of this time period.
moisture in the tumbling clothes,
laundry is dry enough (and the
determines when they are dried
drum air warm enough) the heat
to your pre-selected setting, and
turns off. When the air cools, the
terminates the cycle automatically. heat turns back on. This off and on
Refer to the Controls Setting
cycling may happen a number of
Guide for recommended settings.
times (depending on the fabric, load
The Cycle Selector will not
size and Cycle Selector setting).
advance until clothes have reached
The Cycle Selector advances (when
a certain degree of dryness.
the heat is
o~
until it automatically
turns off the dryer.
Drying Selections Guide for the Automatic Cycles
For the
f~st
few times you use your
dryer set near
●
position and feel
the dried items when the dryer stops.
If they are drier than you would like
set toward Less Dry the next time you
dry a similar load.
If you desire them to be drier, set
toward More”Dry the next time you
dry a similar load.
8
As a general guideline...
Set near
●
position
●
For most normal loads.
Set toward Less Dry
●
For light-weight fabric loads.
c
If you desire to remove less moisture.
“
For very small loads.
Set toward More Dry
●
For loads that include heavy-weight fabrics.
●
If you desire to remove more moisture.
