Gebesa G-CONNECT User manual

G-CONNECT
DESK TO CREDENZA TOP
ASSEMBLY INSTRUCTIONS
Questions?
Call Toll Free 1-844-2GEBESA or email [email protected]

G-CONNECT | DESK TO CREDENZA TOP TOOLS
2
Screw driver Drill
REQUIRED ASSEMBLY TOOLS
NOT INCLUDED
(G)
Leveler
1” x ¼”
2x
(H)
Hand bolt
½” x ¼”
4x
(I)
Hand bolt
1 ½” x ¼”
1x
(J)
Wood screw
8 x 1”
10x
(B)
Front duct
1x
(F)
Worksurface stiffener
1x
(C)
Structural stiffener
1x
(E)
Lateral duct
1x
(K)
Plastic screw
2x

PARTS
3
G-CONNECT | DESK TO CREDENZA TOP
(A)
“O” leg
1x
(D)
Worksurface
1x

STEPS
4
G-CONNECT | DESK TO CREDENZA TOP
1.
REQUIRED ASSEMBLY TOOLS
NOT INCLUDED
Adjust until completely balanced
(G)
(A)
(A)
(G)
(G)

STEPS
5
G-CONNECT | DESK TO CREDENZA TOP
(C)
(A)
2.
Use pressure to attach the structural
stiffener (C) using the plastic screw (K)
on the flange of the “O” leg (A).
(A) (C)
(K)
(K)

STEPS
6
G-CONNECT | DESK TO CREDENZA TOP
3.
(B)
(A)
Insert the front duct
(B) in the leg’s slots (A).
(B)
(A)

STEPS
7
G-CONNECT | DESK TO CREDENZA TOP
4.
Insert the lateral duct (E) over
the previously assambled structure
and repeat steps 2 and 3.
(B)
(C)
(K)
(B)
(C)
(A)

STEPS
8
G-CONNECT | DESK TO CREDENZA TOP
5.
(D)
Attach the stiffener (F) to
the worksurface (D) using
the 8 x 1” wood screws (J).
(J)
(J)
(F)
(D)
(J)
(F)

STEPS
9
G-CONNECT | DESK TO CREDENZA TOP
6. Attach the worksurface (D) to
the structure (BC) using the hand
bolts (H) holding it from the
sliding mechanism (E) attached
to the “O” leg (A).
(E)
(D)
(H)
(C)
(A)
(C)

STEPS
10
G-CONNECT | DESK TO CREDENZA TOP
7.
Add the hand bolt (I) to the
structure (C) to avoid
the worksurface (D) sliding.
(D)
(I)
(C)
(C)
In order for the worksurface
to slide, loose the hand bolt.

FINAL VIEW
11
G-CONNECT | DESK TO CREDENZA TOP
Front view

FINAL VIEW
12
G-CONNECT | DESK TO CREDENZA TOP
Side view
Bottom view

Questions?
Call Toll Free 1-844-2GEBESA or email [email protected]