Gebesa G-CONNECT User manual

G-CONNECT
IRREGULAR DESK TO CREDENZA TOP
ASSEMBLY INSTRUCTIONS
Questions?
Call Toll Free 1-844-2GEBESA or email [email protected]

G-CONNECT | IRREGULAR DESK TO CREDENZA TOP TOOLS
2
REQUIRED ASSEMBLY TOOLS
NOT INCLUDED
(G)
Leveler
1” x ¼”
2x
(H)
Hand bolt
½” x ¼”
4x
(I)
Hand bolt
1 ½” x ¼”
1x
(J)
Wood screw
8 x 1”
10x
(B)
Front duct
1x
(F)
Worksurface stiffener
1x
(C)
Structural stiffener
1x
(E)
Lateral duct
1x
(K)
Plastic screw
2x
Screw driver Drill

PARTS
3
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
(A)
“O” leg
1x
(D)
Worksurface
1x

STEPS
4
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
1.
REQUIRED ASSEMBLY TOOLS
NOT INCLUDED
Adjust until completely balanced
(G)
(A)
(A)
(G)
(G)

STEPS
5
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
(C)
(A)
2.
Use pressure to attach the structural
stiffener (C) using the plastic screw (K)
on the flange of the “O” leg (A).
(A) (C)
(K)
(K)

STEPS
6
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
3.
(B)
(A)
Insert the front duct
(B) in the leg’s slots (A).
(B)
(A)

STEPS
7
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
4.
Insert the lateral duct (E) over
the previously assambled structure
and repeat steps 2 and 3.
(B)
(C)
(K)
(B)
(C)
(A)

STEPS
8
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
5.
(D)
Attach the stiffener (F) to
the worksurface (D) using
the 8 x 1” wood screws (J).
(J)
(J)
(F)
(D)
(J)
(F)

STEPS
9
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
6. Attach the worksurface (D) to
the structure (BC) using the hand
bolts (H) holding it from the
sliding mechanism (E) attached
to the “O” leg (A).
(E)
(D)
(H)
(C)
(A)
(C)

STEPS
10
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
7.
Add the hand bolt (I) to the
structure (C) to avoid
the worksurface (D) sliding.
(D)
(C)
(I)
(C)
In order for the worksurface
to slide, loose the hand bolt.

FINAL VIEW
11
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
Front view

FINAL VIEW
12
G-CONNECT | IRREGULAR DESK TO CREDENZA TOP
Side view
Bottom view

Questions?
Call Toll Free 1-844-2GEBESA or email [email protected]