BrilliantSpa Manual 5
6. When the green LED light becomes illuminated that indicates that
it is ready to begin steaming. Please note that the green LED light
will cycle on and off as the steamer automatically heats up while
maintaining constant pressure.
7. Using the stainless steel jewelry holding tweezers, firmly yet
carefully grasp the item being cleaned and hold it approximately
one inch beneath the steam nozzle located above the mesh
basket or simply place the item being cleaned in the mesh basket.
Please note that the mesh basket may be removed when cleaning
larger items.
8. To begin steaming, press down on the steam release button
located behind the water fill cap in short, one second bursts while
being aware that the longer the item being cleaned is exposed to
the steam the more it will naturally heat up and become hot. Allow
a brief delay between bursts to allow the steamer to rebuild steam.
Rotate the item under the nozzle while positioning it in different
angles to clean it on all sides. Always allow the jewelry being
cleaned sufficient cooling time prior to use.
9. Inspect the item after cleaning and if it requires additional
steam cleaning repeat these steps noted in #8. For dirtier items,
additional steaming time may be required, presoaking in hot
water or for faster results it is recommended to also first use the
GemOro Sparkle Spa personal ultrasonic jewelry cleaner (sold
separately) to loosen up the dirt and pre-clean prior to steaming.
10. When it is necessary to refill the Brilliant Spa, first turn it off and
then unplug it from the power outlet. Press the steam activation
button to release the remaining steam in its tank. Allow sufficient
cooling time of approximately 30 minutes prior to refilling the
tank with 10oz of water. When removing the fill cap after it has
cooled, always unscrew it slowly while allowing the Brilliant Spa to
gradually release any remaining pressure in the tank.
11. When you are finished cleaning your jewelry, unplug the Brilliant
Spa from the power outlet by grasping the end of the power cord
closest to the outlet.