Gen7Pets G7 Jogger User manual

G7 Jogger™Pet Stroller Instructions
Patterns vary
2
Parts List
How to assemble your new stroller
Stroller Frame
Front Wheel Front Wheel Assembly
Rear Wheels and Axle
Parent Tray
Step 1 Step 2
1. Attach front wheel to front wheel assembly. Be
sure to insert silver colored tooth on the wheel
into the open groove on the front wheel fork.
2. Twist long silver colored lever and tighten by
pulling lever up to lock wheel onto the fork.
1. Attach the front wheel onto the front wheel forks
2. Insure that the Valco buttons on the fork are in
correct position with the wheel
3. Push the front wheel onto the front forks until
Valco buttons snap into place
Assemble wheel onto the front fork Assemble front wheel assembly to the frame

Step 3
2
Stroller assembly continued
How to care for your new stroller
1. Pull silver tab on wheel while
inserting center of wheel onto
the axle. (See arrow on
picture to the left)
2. Press firmly on wheel to
ensure a tight fit.
3.Repeat 1 & 2 to insert second
wheel on axle.
Attach rear wheels to axle
Step 4
1. Insert wheel assembly into
both steel tubes.
2. Listen for the snap of the
valco button to be sure
assembly is firmly attached.
3.You can verify a secure fit by
lifting up on the plastic (see
arrows above) if you can see the
silver colored valco buttons.
Assemble rear wheel assembly
to the stroller frame
Step 5
1. Place parent tray on handle
bar and align side holes on
both sides of the tray (see
arrows above) with knobs
on steel tubing and snap
into place.
Attach parent tray
Folding the stroller
1. Unzip the pet compartment and remove pet
2. Remove items from storage basket
3. Using the Smart-Fold Handle Mechanism push the
red button on the underside of the mechanism
4. Next while holding the red button in, squeeze the red
handle completely on the front of mechanism
5. Push the stroller handle down-ward to fold the stroller
Opening the stroller
1. Unlatch locking mechanism.
2. Lift up on handle and pull stroller open to
upright position.
3. Be sure stroller frame locks into place at the
hinges as seen in image #1 with white arrow.
• Clean Fabric with mild household soap and warm water.
• Clean Stroller frame with mild household soap and warm water.
• If wheel squeaks or rotates with difficulty, apply light oil. (e.g. WD-40, 3-in-1, or sewing machine oil)
• Regularly check stroller for loose or missing parts and tighten or replace with Gen7Pets parts.