Genius G-shot P534 User manual

INSTRUCTIONS FOR USE BTE13 SP

Introduction to this booklet
This booklet guides you in how to use and maintain your new
hearing instrument. Please read the booklet carefully including
the Warning section. This will help you to achieve the full benet
of your new hearing instrument.
Your Hearing Care Professional has adjusted the hearing
instrument to meet your needs. If you have additional questions,
please contact your Hearing Care Professional.
About Start up Handling Options Warnings More info
For your convenience, this booklet contains a navigation bar to help
you navigate easily through the dierent sections.
Intended use
The hearing instruments are intended to amplify and transmit sound
to the ear and thereby help compensate for hearing loss. The hearing
instruments are intended to be used by infants, children and teens
with a severe-to-profound hearing loss.
IMPORTANT NOTICE
The hearing instrument amplication is uniquely adjusted and optimized
to your personal hearing capabilities during the instrument tting
performed by your Hearing Care Professional.

Table of content
Warnings
Additionals
About
Start up
Handling
Options
Instrument view 6
Identify left and right hearing instrument 8
Battery (size 13) 9
Turn the hearing instrument on and o 10
When to replace a battery 11
Replace the battery 12
Caring for your hearing instrument 14
Sound hook with earmold 16
Put on the hearing instrument with earmold 17
Put on the hearing instrument with earmold and
SmartFit™ Trainer 18
Clean the earmold 20
Wash the earmold 21
Optional features and accessories 22
Mute the hearing instrument (optional) 23
Change programs (optional) 24
Change volume 26
Volume Control and ConnectLine (Optional) 28
Tamper-resistant battery door (optional) 31
Wireless accessories (optional) 33
Direct Audio Input - DAI (optional) 34
FM (optional) 36
Other options (optional) 38
Audible and visual indicator (LED) summary table 40
Warnings 42
Troubleshooting guide 48
Water resistant (IP58) 50
Conditions 51
Warranty certicate 52
International warranty 53
Mobile phone 54
Technical information 56
Technical Data 61

6 7
About Start up Handling Options Warnings More info
Instrument view
What it is What it does
Push button Change
programs
Volume
wheel
Change volume
and mute the
instrument
Microphone
openings
Sound in
Battery door Contains the battery.
Battery door is also
the on/o switch
Sound hook
Tube
Earmold
Nail grip Open the
battery door
Sound out

8 9
About Start up Handling Options Warnings More info
Identify left and right hearing instrument
It is important to distinguish between the left and the right
instrument as they might be programmed dierently. Insert the
colored indicators provided for your LEFT and RIGHT instruments.
Battery (size 13)
Your hearing instrument is a miniature electronic device that runs
on special batteries. To activate the hearing instrument, you must
insert a new battery in the battery door. See how in the “Replace the
battery” section.
A RED indicator inside the
battery door marks the
RIGHT instrument
A BLUE indicator inside
the battery door marks the
LEFT instrument.
Battery door
Your instrument
battery size is 13
Pull out to open

10 11
About Start up Handling Options Warnings More info
Turn the hearing instrument on and o
The battery door is also used to switch the hearing instrument on and
o. To preserve the battery, make sure your instrument is switched o
when you are not wearing it.
When to replace a battery
When the battery power is low, the visual indicator (LED) will rapidly
blink and the user will hear 2 beeps (if enabled).
Warnings Audible Visual
Battery low warning ee
Battery dead eeee
Battery maintenance tip
To make sure the hearing instrument is always working bring spare
batteries with you, or replace the battery before you leave home.
Turn ON
Close the
battery
door with
the battery
in place.
Turn OFF
Open the
battery door.

12 13
About Start up Handling Options Warnings More info
Replace the battery
2. Uncover 3. Insert
Fully open the
battery door.
Remove the
battery.
Remove the
sticky label from
the + side of the
new battery.
Insert the new
battery into the
battery door.
Make sure the
+ side faces up.
1. Remove
MultiTool
Close the battery door. The
instrument will play a jingle.
Hold the earmold close to your ear
to hear the jingle.
The MultiTool can be used for
battery change. Use the magnetic
end to remove and insert batteries.
The MultiTool is provided by
your Hearing Care Professional.
4. Close Tip

14 15
Caring for your hearing instrument
When handling your hearing instrument, hold it over a soft surface
to avoid damage in case you drop it.
Clean the microphone openings
Carefully brush away debris from the
openings. Gently brush the surface.
Make sure the brush is not pressed
into the openings.
About Start up Handling Options Warnings More info
IMPORTANT NOTICE
Use a soft, dry cloth to clean the hearing instrument. It must never be
washed or immersed in water or other liquids.
The MultiTool
The MultiTool contains a brush and a wire loop for cleaning ear wax
from the earmold. The brush can be replaced and purchased from
your Hearing Care Professional.
Brush
MagnetWire loop
Microphone
openings
IMPORTANT NOTICE
Your MultiTool has a built-in magnet. Keep the MultiTool 12 inches away
from credit cards and other magnetically sensitive devices.

16 17
About Start up Handling Options Warnings More info
Sound hook with earmold
The earmold is customized for you
and ts your ear.
Put on the hearing instrument with earmold
Gently pull your ear outwards
and press the earmold in the
direction of the ear canal,
twisting slightly.
Place the hearing instrument
behind your ear.
Step 1 Step 2

18 About Start up Handling Options Warnings More info
Put on the hearing instrument with earmold and
SmartFit™ Trainer
Your hearing instrument may have SmartFit™ Trainer, a guidance help
for parents and caregivers when inserting the earmold. Your Hearing
Care Professional may enable or disable the SmartFit™ Trainer.
The LED indicator will remain ON for up to 20 seconds while the
system checks the earmold insertion and t. If the earmold is NOT
inserted correctly, a series of rapid blinks on the LED will appear.
If the blinks appear, turn the hearing instrument o and on again,
and reinsert the earmold. It may be possible that the rapid blinks will
continue to appear even after re-inserting the earmold . This is often
an indication that the earmold may be loose and needs replacing. Be
assured that the hearing instrument will still proceed to turn on and
work properly.