GENMAX GM2000i User manual

USER MANUAL
FOR MODELS:
GM2000i
Digital Inverter Generator
1600 Running Watts | 2000 Peak Watts
R

2
CHONGQING DINKING POWER MACHINERY CO., LTD
GM2000i 1600 2000 1.1 4500 79.7 48.6×43 0.09 10W30
(Gel)
A5RTC
(Gel)
For portable generators where the neutral is floating, the operator's manual shall include the
following wording or equivalent:
The portable generator stator winding is isolated from the frame and from the AC receptacle
ground pin; and Electrical devices that require a connection between one conductor pin and the
grounded receptacle pin may not function properly.
NEUTRAL FLOATING

3
LIMITED WARRANTY
Model Number: _____________________________________
Name: ___________________________________________
Serial Number: ______________________________________
Street Address: ___________________________________
Date Purchased: ____________________________________
Purchased From: ____________________________________
City, State, ZIP: ____________________________________
Country: __________________________________________
Phone Number: ___________________________________
E-Mail: ___________________________________________
WARRANTY CARD
1.
R
Email: [email protected] Phone: [phone]

4
LIMITED WARRANTY
Warranty Card
GM2000i
GM2000i
GENMAX
GM2000i
10
10
10
10
10
10
10
11
11
12
13
13
13
14
15
15
15
16
16
17
17
17
18
18
18
19
20
21
21
22
21

5
Connection of the product to a building’s electrical
system is not applicable.

6

7
SAFETY LABELS AND DECALS GM2000i

8
BASIC INVERTER FEATURES GM2000i
3
Fuel Cap and Vent: Open the vent to run the
engine and close the vent when the engine is
off.
9
Fuel Switch: Fuel switch is OFF, and the engine will
not run.

9
GM2000i
11
10 AC Breaker:
to block current.
Parallel Connectors:To increase AC power output,
the connector sockets are used to connect the two
same type generator with special paralleling cords.
The connector sockets is only used to the
communication between the inverters, they can not
used for AC power output.
The special paralleling cords shall be purchase
separately, and they shall be approved by
certification body.
13 Choke Switch: when cold start, properly close part of
the air inlet to improve the engine start performance,
after normal operation, the choke should be fully
open, otherwise the engine can not run properly
because of too thick mixture and cause too much oil
consumption.
ENG.SW. ECO.SW.
OUTPUT
INDICATOR
OVERLOAD
ALARM
LOW OIL
ALARM CO ALARM
CHOKE
AC 120V NEUTRAL FLOATING
PARALLEL
CONNECTORS
AC BREAKER
AC RESET
DC 5V 1A/2.1A
SYSTEM FLOATING 11
12
10
13
12 CO Alarm: Flashing red light: dangerous levels of
carbon monoxide gas have built up leave
immediately until area has aired out. Move generator
to well-ventilated area before operation. Flashing
yellow light: carbon monoxide sensor malfunction.
Sensor needs service.
Fuel Switch: Fuel switch is OFF, and the engine will
not run.
14 Engine Switch: Press ON to start the engine, press
OFF to turn OFF the engine
14
Output Indicator: Indicates the inverter is
ready to be used.
Overload Alarm: Indicates that the inverter is
overloaded.
Low Oil Alarm: Indicates low oil level.

10
GENMAX

11
GENMAX
GENMAX
GENMAX

12
③

13

14
Starting
2. Remove the load from all output ends.
3. Turn off switch to “ON” .
4. Turn ventilation knob of fuel tank cap to “ON”
(see Figure 6).
5. Flip the oil switch to “ON” choke and pull out
(see Figure 7).
ON
OFF
CHOKE
6.

15
ENG.SW. ECO.SW.
OUTPUT
INDICATOR
OVERLOAD
ALARM
LOW OIL
ALARM CO ALARM
CHOKE
AC 120V NEUTRAL FLOATING
PARALLEL
CONNECTORS
AC BREAKER
AC RESET
DC 5V 1A/2.1A
SYSTEM FLOATING
Figure 9
OFF
ON
3. Turn OFF the oil switch,Turn OFF the switch
. (see Figure 9)
4. After the generator has completely cooled down, turn
ventilation knob on fuel tank cap to OFF.
(see Figure 9).
(see Figure 10).
Figure 10

16

17
Figure 11
Figure 11.
Figure 11.

18
(see Figure 12).
Figure 12
Figure 14
(see Figure 14).

19
Figure 15
(see Figure 15).
(see Figure 16).
Figure 16
(see Figure 17)
Figure 17

20
Figure 18
(see Figure 18)
Figure 19
(see Figure 19).