GENMAX GM6000iE User manual

USER MANUAL
FOR MODELS:
GM6000iE/GM6000iED
Portable Inverter Generator
5250(GAS.)/4750(LPG) Running Watts | 6000(GAS.)/5500(LPG) Peak Watts
R

2
CHONGQING DINKING POWER MACHINERY CO., LTD
GM6000iE 5250 6000 3.5 3600 312 80×62 0.21 10W30
(Gal)
A5RTC
(Gal)
GM6000iED 5250(GAS.)
4750(LPG)
6000(GAS.)
5500(LPG) 3.8 3600 312 80×62 0.21 10W30A5RTC

3
LIMITED WARRANTY
Model Number: _____________________________________
Name: ___________________________________________
Serial Number: ______________________________________
Street Address: ___________________________________
Date Purchased: ____________________________________
Purchased From: ____________________________________
City, State, ZIP: ____________________________________
Country: __________________________________________
Phone Number: ___________________________________
E-Mail: ___________________________________________
WARRANTY CARD
1.
R
Email: [email protected] Phone: [phone]

4
LIMITED WARRANTY
Warranty Card
GENMAX Generator
11
11
11
11
11
11
11
12
12
13
14
14
14
15
16
16
16
17
17
18
18
18
19
19
19
20
21
22
22
23
22
SCHEMATICS 24
Generator
Generator
Generator
Generator
Generator

5
Connection of the product to a building’s electrical
system is not applicable.

6
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator.
generator
generator

7
SAFETY LABELS AND DECALS
6
6
generator
generator
generator

8
BASIC GENERATOR FEATURES
3
7
Fuel Cap: Open the fuel tank cap and fill with
proper amount of gasoline.

9
GM6000iE
10
11
AC Breaker:
to block current.
3RV30
3
Multifunction Digital Display Meter: Yellow light
means that the amount of oil is too low, red light
means that the machine overload, green light
means normal operation; Power display on the
left, oil level display on the right; Rolling display
mode, respectively display accumulative running
time, output voltage, frequency rolling display
mode.
Circuit Breake: A circuit breaker interrupts the
current when the whole circuit is overloaded.
AC 120V NEUTRAL FLOATING AC 120V NEUTRAL FLOATING
AC BREAKER
AC BREAKER
CIRCUIT BREAKER
ON
OFF
AC 120V/240V
NEUTRAL FLOATING
AC RESETCO ALARM ECO.SW.
DC 5V 1A/2.1A
SYSTEM FLOATING
11
2
10
4
CO Alarm LED: Flashing red light: dangerous levels
of carbon monoxide gas have built up leave
immediately until area has aired out. Move generator
to well-ventilated area before operation. Flashing
yellow light: carbon monoxide sensor malfunction.
Sensor needs service.
Engine Switch: Switch to ON to turn ON the fuel,
then hold down to start the generator.
generator
generator.
generator
generator.

10
GM6000iED
10
11
Multifunctional LED Digital Display Meter: Red
light (LOW OIL) means that the amount of oil is
too low, red light (OVERLOAD) means that the
machine overload, green light (POWER) means
normal operation. LED Digital Display shows
time, voltage, power, frequency and oil level;
Time: scrolling display of single running time and
accumulated running time; voltage: scrolling
display of 120V and 240V.
Main Breake: A circuit breaker interrupts the current
when the whole circuit is overloaded.
CO Alarm LED: Flashing red light: dangerous levels
of carbon monoxide gas have built up leave
immediately until area has aired out. Move generator
to well-ventilated area before operation. Flashing
yellow light: carbon monoxide sensor malfunction.
Sensor needs service.
4
2
11
10
12
Main SW.: Manage battery power and shutdown.
AC Protector: If the generator is overload, the AC
protector will trip to block current.
One Push Start: Press this button, the engine
can start and stop.
12
120-Volt/240-Volt, 30-Amp Outlet (NEMA L14-30):
The outlet is capable of carrying a maximum of 30
amps.
generator
generator.
generator.

11
GENMAX
Carbon Monoxide Specification
CO DETECT technology monitors the accumulation of
carbon monoxide (CO), a poisonous gas produced by
engine exhaust when the generator is running. If CO
Sensor detects unsafe elevated levels of CO gas, it
automatically shuts off the engine. CO Sensor is not a
substitute for an indoor carbon monoxide alarm or for
safe operation. DO NOT allow engine exhaust fumes to
enter a confined area through windows, doors, vents or
other openings. Generators must ALWAYS be used
outdoors, far away from occupied buildings with engine
exhaust pointed away from people and buildings. Meets
the requirements of ANSI/PGMA G300-2018.
GENERATOR
GENERATOR,
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
Generator
generator

12
GENMAX
GENMAX
GENMAX
generator
generator
generator
generator
generator
generator
GENERATOR
generator
generator
generator
generator
generator
generator
generator
generator
generators’
generator
generator
generator.

13
generator

14
generator
generator
generator
generator
generator
generator
generator
generator

15
Hand Starter
1. Remove all the loads out of the output;
2. Turn the four-in-one switch to “CHOKE START”;
3. (see Figure 6)Then quickly pull the starting handle ;
4. After the generator starts, turn the four-in-one
switch to “RUN” and the generator can be used
normally with load.
NOTICE: Turning the four-in-one switch to “CHOKE
START” and pressing the red button for more than
5 s will damage the starting motor. If startup fails,
release the switch and wait 10 seconds before
restarting.
If the speed of the starter motor drops rapidly after
a period of time, it means that the battery should be
recharged.
1. Remove all the loads out of the output;
2. Turn the four-in-one switch to “CHOKE START” and
press the red button for 3-5 s before releasing the
generator;
3. Then turn the four-in-one switch to “RUN” and the
generator can be used normally with load.
Electric starting
Figure 6
WARNING: When the generator is started in warm
state, there is no need to turn the four-in-one switch
to “CHOKE START”.
Dual Fuel
1. Press the main switch to "ON". The start button will
light up for 2-3 seconds and then go off;
2. Switch the oil/gas switch to GAS. (or LPG);
3. Press the start button after the generator starts, the
generator runs normally;
4. After the generator starts, turn the four-in-one
switch to “RUN” and the generator can be used
normally with load.
Tip: The generator needs to switch from fuel oil to
gas state (or gas to fuel oil state) during normal
operation. The generator must be directly turned to
fuel oil or gas gear under no-load state to load and
use normally.
Procedure For Connecting Gas Pipes
1. Connect the dedicated gas hose to the generator;
2. Switch the oil/gas switch to the GAS. switch;
3. Press the start button after the generator starts, the
generator runs normally;
4. Open the air valve on the fuel tank and start the
generator according to the normal start-up steps.
GENERATOR
GENERATOR,
generator,
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator
generator

16
1. Remove all loads in the output;
2. Turn the four-in-one switch to “OFF”, and the
generator stops running.
(see Figure 7).
Figure 7
AC 120V NEUTRAL FLOATING AC 120V NEUTRAL FLOATING
AC BREAKER
AC BREAKER
CIRCUIT BREAKER
ON
OFF
AC 120V/240V
NEUTRAL FLOATING
AC RESETCO ALARM ECO.SW.
DC 5V 1A/2.1A
SYSTEM FLOATING
GENERATOR
generator:
generator
generator
generator
generator
generator
generator
generator
generator
generator.
generator
generator.
generator.

17
GENERATOR
generator
generator
generator generator
generator

18
Figure 8
Figure 8.
Figure 8.
generator
generator
generator

19
(see Figure 9).
Figure 9
Figure 10
(see Figure 11).
Figure 11
Air Cleaner Element
Air Cleaner Cover
Clip
generator
generator
generator
generator

20
(see Figure 12).
Figure 12
(see Figure 13).
Figure 13
(see Figure 14)
Figure 14
generator