GENMAX GM6000iED User manual

GM6000iED Choke stepper motor
maintenance operation instructions
2022.6.9

Tool Introduction
电枪
Hand tools are also available:
1. Cross screwdriver
2. Tweezers or other sharp tools
cross gun

1 Removing the panel rear cover
•Before •After
1.Turn the knob to remove the battery
door; remove the 6 bolts with a cross
screwdriver or stun gun.
3. Throttle stepper
motor connection
box (if it cannot be
recognized,
disassemble the left
appearance cover）
2.Remove
the battery
door

2、Remove the left exterior cover
•Before •After
1.Use a cross
screwdriver or flathead
screwdriver to remove
the two bolts
3.You can feel it with
your hand to adjust the
position of the damper.
2.Snap the cover
down and remove
the cover
open choke
status

3、Check wiring
•Panel box (male plug) •Stepper motor socket
(female socket)
Yellow、 Orange、 Red
Pink（Black Red）、Blue、
blank
Red、orange、Yellow
Blank、Blue、Pink
1.Check whether the
wiring harness of the
plug-in box is correct
according to the picture
2.Observe whether the
pins are loose or
deformed.

4、repair
1.Use tweezers or
other sharp tools to
flatten the terminals.
2.Pull the terminal
out of the socket.
3.Lift up the reverse
button of the
terminal
4.Insert the wire harness
into the correct position
according to the diagram in
step 3, then push the
terminal inward, the
terminal will not come
loose。

5、Install
•Joint the two sockets
Note: When docking the socket, be careful not to insert the pins crookedly.

6、Install the panel rear cover
•Install the panel rear cover
1.Assemble the panel
back cover in place and
assemble the 6 Phillips
bolts.
2.Install the battery
door and lock the knob
in the vertical direction

7、Install the left exterior cover
Install the left exterior cover
Assemble the cover
plate in place and fasten
the two Phillips bolts.

8、Start-CO Alarm Self-Test
4.The CO alarm self-test flashes
the yellow light once and goes
out, indicating that the self-test is
successful and the CO alarm is
working normally.
1.Turn the switch to the fuel
gear and start again (after the
fuel tank is refueled).
2.Press the switch
to "ON" 3. Press the One
key start button to
start