GeoMax ZIPP10 pro series User manual

Zipp10 Series - 1 -
Installation Guide © 2013 GeoMax AG, Widnau, Switzerland
GeoMax TPS
Zipp10 Pro Series
Installation Guide
Version 1.0
English

Zipp10 Series - 2 -
Installation Guide © 2013 GeoMax AG, Widnau, Switzerland
Tablet of Contents
1 INTRODUCTION..............................................................................3
2 PREPARATION OF THE INSTRUMENT ..................................................3
2.1 Battery Charging..........................................................................................3
2.2 Obtaining Firmware Files .............................................................................3
2.3 Uploading to the Instrument....................................................................... 4

Zipp10 Series - 3 -
Installation Guide © 2013 GeoMax AG, Widnau, Switzerland
1 INTRODUCTION
This guide provides complete step-by-step instructions for preparing the Zipp10 Pro total
station series for measuring work.
The latest versions of GeoMax documents and software referred to in this document are
all available from the GeoMax Parner Area in the Zipp10 Pro folder at www.geomax-
positioning.com/partner-area
Only the tasks required for the initial setup are described in this document. For further
information regarding the operation of the Zipp10, please refer to the respective manuals.
The Zipp10 Quick Guide is included with the container set. The comprehensive User
Manual is available from the included USB stick and also from GeoMax Partner Area in the
Zipp10 folder at www.geomax-positioning.com
2 PREPARATION OF THE INSTRUMENT
2.1 BATTERY CHARGING
Before using the instrument, the included ZBA301 battery should be charged. Insert the
battery into the ZCH301 charger and plug the adapter into an AC supply. Do not
disconnect from power until the green FULL indicator flashes, indicating that the battery is
fully charged. Once charged, insert the battery into the side cover slot of the Zipp10
instrument and switch on.
2.2 OBTAINING FIRMWARE FILES
When receiving a new instrument, it should be checked that the latest firmware version is
installed. The installed version can be seen on the Software Information page, accessed
by pressing MENU / (5)-Setting / (3)-System Info. / (F1)-SW. If the displayed firmware
version does not match the one available from Geomax Partner Area, then the instrument
should be updated.

Zipp10 Series - 4 -
Installation Guide © 2013 GeoMax AG, Widnau, Switzerland
To customize the instrument for personel requirements, the firmware file in the required
language and coordinate order should be installed. The respective files can be obtained
from Geomax Partner Area in the Zipp10/Firmware folder and are in the format
Zipp10_XX_ENH.fw or Zipp10_XX_NEH.fw where “XX” indicates the language.
Choose either “ENH” or “NEH” depending on the coordinate order display required. The
firmware files also contains all available applications.
2.3 UPLOADING TO THE INSTRUMENT
The firmware file is uploaded to the instrument directly from the USB stick. Therefore
copy the downloaded file to the System directory on the USB stick using a PC. Insert the
stick into the instrument and power on. To load the file onto the instrument, choose
MENU / (8)-Upload Fw / (1)-Firmware. The contents of the System directory are now
shown. Select the firmware file and choose (F1)-OK to start the upload process.
Note: Ensure that a fully charged battery is inserted when uploading firmware. This
process can take some time and the power supply must NOT be interrupted during the
loading process.
Your Zipp10 instrument is now ready for use.