GET GFHT2 User manual

FAN HEATER GUARANTEE
GET guarantees that this fan heater will be free from defects in
workmanship and materials for a period of 1 year from the date of
purchase.
Any product found to have defects in workmanship or material within
the period of this guarantee will be replaced free of charge.
The conditions of this guarantee are as follows:
A) The product has been properly maintained.
B) Defects or damage due to normal wear and tear, accident, misuse,
or interference are not included.
C) The product is made available for inspection, together with proof of
purchase.
NB. This guarantee does not affect your statutory rights.
NOTE:
This product should not be disposed
of with household waste
Please recycle where facilities exist.
Check with your local authority for
recycling advice.
GET Plc., Key Point, 3-17 High Street, Potters Bar, Herts EN6 5AJ
Helpline Telephone No. 0121 565 7770
AR0490 Ed.D
INSTRUCTION MANUAL
2kW Fan Heater
Models: G2FHT2 - with Thermostat
G2FH2 - without Thermostat
Please read these instructions carefully before use and keep for future
reference.
NOTE:- THIS HEATER IS INTENDED FOR DOMESTIC USE ONLY
Precautions
•In order to avoid overheating do not cover the heater or obstruct the
grilles.
•Do not use near curtains or other combustible materials.
•Young children or infirm persons must not use the heater without
supervision.
•Do not insert objects into any opening on the heater as this may cause
electrical shock or over heating.
•If the appliance is damaged or faulty a qualified service engineer must
repair it.
•The heater must not be used immediately below a socket outlet.
•Unplug the heater when it is not in use.
•Do not use outdoors.
•Do not use the heater near to a bath, shower or swimming pool.
•Do not operate or leave the heater running when it is unattended.
•In order to avoid a hazard due to inadvertent resetting of the thermal cut-
out, this heater must not be supplied through an external switching
device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
•Do not use on deep pile carpet
•Do not use in areas where vapour from gas, paint or other flammable
substances could be present.
•Prevent water from getting into the unit including when it is in storage.

Installation
Position
The heater must only be used on a horizontal stable surface.
Operation
Turning on
The switch has four settings:
Off
Cool Air - fan only
Warm Air – half power
Warm Air – Full power
Thermostat (Not available on G2FH2)
•The thermostat operates by increasing temperature when the knob is
turned clockwise.
•Turn the thermostat fully clockwise.
•When the room has reached the required temperature turn the
thermostat slowly anticlockwise until a click is heard and the indicator
light turns off.
•The temperature is now set and the heater will switch on and off to hold
the temperature.
Frost protection
The frost watch setting is used to prevent the room temperature from falling
below approximately 5°C (depending on the size of the room).
•Choose the power level desired on the heat control switch.
•Turn the thermostat knob to the “” symbol. The heater will now switch
on automatically if the room temperature falls below 5°C.
Safety Cut-out
•The fan heater includes a self-resetting safety device to automatically
switch off the heater in the case of overheating.
•If the heater turns off in use due to overheating, turn the switch to “OFF”,
remove the plug from the socket, and let the unit cool down for at least
10 minutes. Remove any item that may have caused a reduction in
airflow. Then plug the heater in and switch to “ON”.
•If the same situation repeats unplug the heater and have it serviced by a
qualified service engineer.
Plug Replacement
Maintenance
•The only maintenance required is cleaning of the outside.
•Before you clean the unit turn the switch to “OFF”. Remove the plug from
the socket and wait until the heater cools down.
•Use a damp cloth to wipe the outside of the heater.
•Do not use water, detergents, abrasive cleaning materials or chemical
agents (alcohol, petrol etc.) to clean the unit.
•There are no user serviceable parts inside. Qualified service personnel
only should carry out repairs.
If the plug is damaged and requires replacement, follow the wiring instructions
supplied with the new plug.
•The blue wire must be connected to the
terminal marked with the letter N or
coloured black.
•The brown wire must be connected to the
terminal marked with the letter L or
coloured red.
•A 13 amp plug (BS 1363) fitted with a
13 amp fuse (BS 1362) must be used.
NOTE: THIS HEATER IS DOUBLE INSULATED AND THEREFORE DOES
NOT REQUIRE AN EARTH CONNECTION.

Installation
Position
The heater must only be used on a horizontal stable surface.
Operation
Turning on
The switch has four settings:
Off
Cool Air - fan only
Warm Air – half power
Warm Air – Full power
Thermostat (Not available on G2FH2)
•The thermostat operates by increasing temperature when the knob is
turned clockwise.
•Turn the thermostat fully clockwise.
•When the room has reached the required temperature turn the
thermostat slowly anticlockwise until a click is heard and the indicator
light turns off.
•The temperature is now set and the heater will switch on and off to hold
the temperature.
Frost protection
The frost watch setting is used to prevent the room temperature from falling
below approximately 5°C (depending on the size of the room).
•Choose the power level desired on the heat control switch.
•Turn the thermostat knob to the “” symbol. The heater will now switch
on automatically if the room temperature falls below 5°C.
Safety Cut-out
•The fan heater includes a self-resetting safety device to automatically
switch off the heater in the case of overheating.
•If the heater turns off in use due to overheating, turn the switch to “OFF”,
remove the plug from the socket, and let the unit cool down for at least
10 minutes. Remove any item that may have caused a reduction in
airflow. Then plug the heater in and switch to “ON”.
•If the same situation repeats unplug the heater and have it serviced by a
qualified service engineer.
Plug Replacement
Maintenance
•The only maintenance required is cleaning of the outside.
•Before you clean the unit turn the switch to “OFF”. Remove the plug from
the socket and wait until the heater cools down.
•Use a damp cloth to wipe the outside of the heater.
•Do not use water, detergents, abrasive cleaning materials or chemical
agents (alcohol, petrol etc.) to clean the unit.
•There are no user serviceable parts inside. Qualified service personnel
only should carry out repairs.
If the plug is damaged and requires replacement, follow the wiring instructions
supplied with the new plug.
•The blue wire must be connected to the
terminal marked with the letter N or
coloured black.
•The brown wire must be connected to the
terminal marked with the letter L or
coloured red.
•A 13 amp plug (BS 1363) fitted with a
13 amp fuse (BS 1362) must be used.
NOTE: THIS HEATER IS DOUBLE INSULATED AND THEREFORE DOES
NOT REQUIRE AN EARTH CONNECTION.

FAN HEATER GUARANTEE
GET guarantees that this fan heater will be free from defects in
workmanship and materials for a period of 1 year from the date of
purchase.
Any product found to have defects in workmanship or material within
the period of this guarantee will be replaced free of charge.
The conditions of this guarantee are as follows:
A) The product has been properly maintained.
B) Defects or damage due to normal wear and tear, accident, misuse,
or interference are not included.
C) The product is made available for inspection, together with proof of
purchase.
NB. This guarantee does not affect your statutory rights.
NOTE:
This product should not be disposed
of with household waste
Please recycle where facilities exist.
Check with your local authority for
recycling advice.
GET Plc., Key Point, 3-17 High Street, Potters Bar, Herts EN6 5AJ
Helpline Telephone No. 0121 565 7770
AR0490 Ed.D
INSTRUCTION MANUAL
2kW Fan Heater
Models: G2FHT2 - with Thermostat
G2FH2 - without Thermostat
Please read these instructions carefully before use and keep for future
reference.
NOTE:- THIS HEATER IS INTENDED FOR DOMESTIC USE ONLY
Precautions
•In order to avoid overheating do not cover the heater or obstruct the
grilles.
•Do not use near curtains or other combustible materials.
•Young children or infirm persons must not use the heater without
supervision.
•Do not insert objects into any opening on the heater as this may cause
electrical shock or over heating.
•If the appliance is damaged or faulty a qualified service engineer must
repair it.
•The heater must not be used immediately below a socket outlet.
•Unplug the heater when it is not in use.
•Do not use outdoors.
•Do not use the heater near to a bath, shower or swimming pool.
•Do not operate or leave the heater running when it is unattended.
•In order to avoid a hazard due to inadvertent resetting of the thermal cut-
out, this heater must not be supplied through an external switching
device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
•Do not use on deep pile carpet
•Do not use in areas where vapour from gas, paint or other flammable
substances could be present.
•Prevent water from getting into the unit including when it is in storage.
This manual suits for next models
1
Table of contents
Other GET Heater manuals
Popular Heater manuals by other brands

Northern Radiator
Northern Radiator AH545 installation instructions

Eterna
Eterna PFH2400 installation instructions

Supply Chain Sources
Supply Chain Sources Lifesmart LS-8WIQH-LB manual

TaoTronics
TaoTronics TT-HE007 user guide

mecanair
mecanair Thermo Sphere PH-960XN owner's manual

Holmes
Holmes HOH2501 owner's guide