getemed VitaGuard VG310 Manual

VitaGuard®VG310 – short instructions
This instruction leaflet does not replace the manual. If you
are not familiar with the manual, thepatient’s health may
be at risk. Please take sufficient time to read the manual.
LED “External
power adapter”
Navigation
keys
<Esc> key for pausing the acoustic
alarm and to exit menus
<Enter> key
for switching on
and confirming
settings
LED flashes
synchronously
with pulse
LED „Alarm“ flashes
red for physiological
and yellow for
technical alarm.
LED “Rechargeable
battery is loading”
Current value of
the respective
vital function
Currently set
alarm limits

Summary of steps before monitoring
 Insert the battery or batteries (do notswitch on yet!).
 Use the external power adapter to connect VitaGuard® to the
supply network (do not switch on yet!).
 Attach the SpO2sensor to the patient.
 Connect the SpO2patient cable to VitaGuard®.
 Connect the SpO2sensor to the patient cable.
 SwitchonVitaGuard®.
Make sure that after the monitor is switched on the indicator lamps
light up briefly and a short sound is emitted by the alarm buzzers.
Check that the alarm limits displayed are the same as those recom-
mended by the doctor.
Switching off VitaGuard®
Always switch off VitaGuard® in the manner described here.
1 Pressthe <Enter> key and keep thispressed: the messagePress
Esc key appears.
2 Briefly press the <Esc> key, still keeping the <Enter> key pressed,
and thenrelease bothkeys.
The switch off command is acknowledged by two short beeps.
Data must be stored before the device finally switches off. For this
reason, VitaGuard® needs about another two seconds after the keys
are released until it switches off completely.

SpO2
Sensor
SpO2 patient
cable
External
power adapter

Distributor:
Manufacturer:
getemed
Medizin- und Informationstechnik AG
Oderstraße 77
D-14513 Teltow
Tel. [phone]
Fax [phone]
E-Mail [e-mail]
Internet www.getemed.de
REF-Nr.:.7382 3021 0027H1-LAB-Rev-A-VitaGuard-VG310-Kurz-GA-ENG.doc 8/24/2005 2:21