Giant Alarm System JJ-RC-F8 User manual

JJ--RC-F8 Remote control Manual
、 type: remote control
二、 IC：HCS301
三、 Modulation: ASK
四、 The frequencyrange: 433.92MHz ±100KHz
五、 The numberofchannels: 1
六、 Frequency stabilizationmode:soundfrequency
stabilization
七、 Antenna: on-board PCB antenna0dBi
八、 Operating voltage: 6V
九、 Workingcurrent: 10mA

十、 Photo：
十 、 Operation:Theremote control uses HCS301
encoderchip,ensuringeverylaunchofthe code
and thelast launch of thecodeis not repeated,
whichcanprevent thecodecopied byothers,
resulting in security issues.When the user
presses thebutton showninthefigure,when
shownthe LED will light, indicatingthesuccess
of thislaunch,whentheuserstops pressing the
keyaftertheLEDlightsburnout,firing
stopped.

changesormodificationsnotexpresslyapproved bythe partyresponsible forcompliance
could voidthe user'sauthorityto operatetheequipment.
NOTE:Thisequipmenthasbeen tested and found to complywith the limitsfora
Class Bdigitaldevice, pursuantto Part 15 ofthe FCC Rules.Theselimitsare
designed to provide reasonableprotection againstharmfulinterference in a
residentialinstallation. Thisequipmentgenerates, usesand can radiateradio
frequencyenergy and, if notinstalled and used in accordance withthe
instructions, maycause harmfulinterference toradio communications. However,
there isno guarantee thatinterference will notoccurina particularinstallation.
Ifthisequipmentdoescause harmfulinterference toradio ortelevision reception,
which can be determined by turningthe equipmentoff and on, the useris
encouraged totrytocorrectthe interference byone ormore ofthefollowing
measures:
-- Reorientorrelocatethe receivingantenna.
-- Increase the separation betweenthe equipmentand receiver.
-- Connectthe equipmentinto an outleton a circuitdifferent
fromthatto which the receiverisconnected.
-- Consult the dealeroran experienced radio/TVtechnician for
help.
FCC ID:WSYJJ-RC-F8
Thisdevice complieswithPart 15 ofthe FCC Rules.Operation
issubjecttothe followingtwo conditions:(1)thisdevice may
notcauseharmfulinterference, and (2)thisdevice mustaccept
anyinterference received, includinginterference thatmaycause
undesired operation.