Giant Alarm System JJ-RC-SM24-LT User manual

Manual of JJ-RC-SM24-LT
Description:
Frequency: 310mhz、315mhz、318mhz、372mhz、390mhz etc.
Working current: 13ma±2ma
Operation：
Open the sliding cover, you will see the program button and Dip Switch.
How to select the brand?
Press the program button, release the button until LED lights.
Select a button to program. According follows table to select brand.
Press button__ times ensuring LED stops flashing after each press. Then
press another button to confirm.
LED flashes, select brand is successfully.
NOTE: Button 1 and Button 2 is independly. It can select different brand
and frequency.
#of times to
press button
Brand
Type/Color of Smart/Learn
Frequency
1
Linear
Mega code
318M
2
Chamberlain
Orange
390M
3
Chamberlain
Purple
315M
4
Chamberlain
Green
390M
5
Genie Overhead door
Intelli code
315M
6
Genie Overhead door
Intelli code
390M
7
Stanley
Secure Code
310M
8
Liftmaster
Frequency hopping
to avoid Frequency
interference
310/315/390
9
Wayne Dalton
Rolling code
372.5M
10
Chamberlain
9 Position
390M
11
Chamberlain
9 Position
315M
12
Genie
12 Position
390M

13
Linear Multicode
10 Position
300M
14
Chamberlain
8 Position
390M
15
Stanley/Multicode
10 Position
310M
16
Genie
9 Position
390M
17
Linear Moore-O-Matic
8 Position
310M
18
Chamberlain
7 Position
390M

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.