
8
Shower
The shower can be used at any time. To do so, pick up
the white hand shower from its holder and open the
“SHOWER VALVE” (in counter clockwise direction). Press
and hold the trigger on the hand shower’s handle to
begin showering. When you are finished showering,
close the valve. Afterwards release the pressure from
the hose by briefly pressing the trigger once again.
Then put the hand shower back into its holder.
Caution: Check the water temperature with your bare hand before
bringing the client in contact with the water.
Setting the temperature
You can set the temperature for tub fill and shower
continuously. To do that, turn the knob of the mixing
valve to the desired position. The current water tem-
perature in the pipe (right after the mixing valve)
will be shown in the display.
Note: For safety reasons the temperature is mechanically
limited to 38 °C (standard mixer). To override this
security mechanism, press the button on the knob.
Thereby it is possible to turn the button further and
reach a higher temperature.
Caution: When setting the temperature to a value above 38 °C,
set it back to 38 °C or lower as soon as possible! In
the meantime, while the temperature is overridden, use
extreme caution with the hot water.
Temperature display
This display always shows the current water tempera-
ture in the pipe (right after the mixing valve).
Caution: In case the water in the pipe had time to cool off,
then the display might show a far lower temperature
than the water temperature which might set in shortly
after the begin of the water flow.
Additionally check the water temperature with your
bare hand before bringing the client in contact with
the water.
Functions