PN 9110.01417 REV 1.0 April 18, 2000 1 of 8
©2000GlenayreElectronics,
@ctiveLink Module
Glenayre’s @ctiveLinkTM SpringboardTM Expansion Module converts your VisorTM Handheld
into an interactive mobile communication device. The @ctiveLink module works both indoors
and out, giving you a reliable, wireless connection to your office, home, and the internet.
The @ctiveLink module is constantly on and communicating, giving you access to any Internet-
based messaging and information services your wireless carrier supports. When you insertit into
the Springboard expansion slot, the Visor Handheld’s user interface screen displays your
incoming communications and lets you compose and send your own messages.
Even when the the @ctiveLink module is removed from the Visor Handheld, it maintains your
wireless link. It continues to collect new messages, storing them in the module’s onboard
memory. It uses flashing LEDs and/or optional audible alerts to notify you of message arrival.
Use the information in this booklet to set up your @ctiveLink module and get acquainted with its
features. Then use your new wireless device to stay in touch, anywhere.
The first time you use your @ctiveLink module you need to:
• Install the batteries (see page 1)
• Turn your @ctiveLink module on (see page 3)
• Insert the @ctiveLink module into the Springboard expansion slot (see page 3)
• Configure your handheld (see page 5)
• Contact your wireless carrier to activate two-way service for your module (see page 5)
Any time you use your @ctiveLink module you may need to know how to do the following:
• Launch the application (see page 5)
• Silence any audible message alerts (see page 5)
• Check out your network coverage (see page 6)
• Read the LEDs (see page 7)
• Remove @ctiveLink from the Springboard slot (see page 7)
• Turn the @ctiveLink module off (see page 8)
Putting Batteries into the @ctiveLink Module
1. Place your fingers on the two door latches and pull the door towards you, lifting it off the
Module.
