Glide Gear Dev Dolly Pro User manual

User Manual
For more informaon please visit our website: www.glidegear.net
Dev Dolly Pro

What’s in the box
For more informaon please visit our website: www.glidegear.net
(1)
(2)
(5)
(3)
(4)
(6)
(7) (8)
(9)
(1) Sled
(2) 4x sets of wheels
(3) 2x end spacers
(4) 1x low prole spacer
(5) 7.5” camera riser
(6) Camera plate, 75mm and 100mm
bowl adapters
(7) 3x Baby pin adapters
(8) 2x An-lt brackets
(9) Carry Case

Assembly
For more informaon please visit our website: www.glidegear.net
1Mount the 4 sets of wheels at each corner
of the sled.
Use the end spacers to clamp each track
extremity as in the picture on the le.
Use the supplied long thumb screws to
lock the track into posion.
The Dev Dolly Pro can accommodate
tracks from 1” to 2” in diameter (25 to
50mm).
2
Thumb screw
Height
adjustment
1”to 2” pipes
(25mm-50mm)

Assembly
For more informaon please visit our website: www.glidegear.net
3Mount the an-lt brackets on
each side of the sled.
Bracket adjustment
Adjust the posion of the bracket so it
goes under the track to prevent the
sled from lng out.
An-lt bracket

Track Mounng Opons
For more informaon please visit our website: www.glidegear.net
Mounng holes
The Dev Dolly Pro features mounng holes at the
boom of each spacer so that it can be mounted on
any tripod.
In addion, 3 baby stand adapters are supplied.
Simply screw the adapter at the boom of a spacer
to mount the Dev Dolly Pro onto a baby stand.
Baby pin adapter
For longer tracks, it is recommended to
place the low prole spacer in the middle
for extra support.
The low prole spacer has the same
mounng opon than the other
spacers.
Low prole spacer

For more informaon please visit our website: www.glidegear.net
Camera Mounng Opons
The Dev Dolly Pro includes: a 7.5”camera riser, a 75mm bowl adapter and a 100mm bowl
adapter. The bowl adapters can be used directly on the sled or on the camera riser.
To mount a bowl adapter onto the sled or the riser:
 remove the 3 screws
 Swap the plate with a bowl adapter
 Mount the bowl adapter using the 3 screws
To mount the riser onto the sled, simply screw the
riser’s base plate on the sled’s mounng screw.