Glide Gear F2F 25 User manual

F2F 25
USER MANUAL

For more informaon please visit our website: www.glidegear.net
What’s included?
Main Frame (A)
Mirror Hood (C)
Beam Splier Hood (B)

Assembly
Mount the F2F 25 onto a tripod.
To dierenate the boom from the top side of the F2F 25:
• the Velcro strips are on the outside of the Main Frame (A)
at the top and on the inside at the boom of it as shown
in Fig. 1.
• The notches in the center plates of the Main Frame (A)
are closer to the boom.
1
Fig. 1
Top side
2Completely open the 2 panels on the side of the Main
Frame (A).
When fully opened, the 2 panels should be paralleled
to each other as shown in Fig. 2.
Fig. 2

Assembly
Aach the Mirror Hood (C) around the mirror panel using
the Velcro strips as shown in Fig. 3.
Make sure the Mirror Hood (C) is ght around the panel so
that light does not go through.
3
Fig. 3
4Aach the Beam Splier Hood (B) around the
beam splier frame using the Velcro strips
around it as shown in Fig. 4.
Make sure the Beam Splier Hood (B) is ght
around the frame so that the light cannot get
through, which will aect how clearly you can see
the reecon of the person you will be talking to
while recording.
Fig. 4

Assembly
Place you camera in front of the Beam Splier
and on the opposite side of the Mirror.
Place the sock around the lens to prevent any
light from geng in.
Your setup should look as in Fig. 5.
5
Fig. 5
6The interviewer should stand next to the
camera facing the mirror.
The interviewee should face the camera
as shown if Fig. 6.
Fig. 6
You are set. Enjoy direct eye contact during
your interviews.