Gliderol TM-27 User manual
TM-27 Single Button Handset
Programming New or Additional Handsets
www.gliderol.com.au
The following instructions demonstrate how to program a new or additional Gliderol Single Button
Handset to suit most Gliderol operators pre-1998. Older Gliderol units operate using either Trinary or
Binary coding. Trinary units will have a 9 digit code shown inside the operator Control Box, whereas
Binary units will have two 8 digit codes inside their Control Box. Please refer to the appropriate set of
instructions to successfully program your new Gliderol Single Button Handset.
Step 1:
Remove the cover from the handset to expose
the handset circuit board.
Step 2:
Push the numbered switches ‘up’ or ‘down’ to
reflect the same code shown inside your existing
control box.
Your handset programming
is now complete!
Should you require further assistance
in programming your Gliderol Single Button
Handset please contact your local
Gliderol oce on 1300 799 177.
REMOVE
COVER
Trinary Handset Coding - 9 digit code
CODE
SWITCHES
TM-27 Single Button Handset
Programming New or Additional Handsets
www.gliderol.com.au
The following instructions demonstrate how to program a new or additional Gliderol Single Button
Handset to suit most Gliderol operators pre-1998. Older Gliderol units operate using either Trinary or
Binary coding. Trinary units will have a 9 digit code shown inside the operator Control Box, whereas
Binary units will have two 8 digit codes inside their Control Box. Please refer to the appropriate set of
instructions to successfully program your new Gliderol Single Button Handset.
Binary Handset Coding - 16 digit code (2 x 8 digit codes)
Binary to Trinary Conversion Table
BINARY SWITCH A UP UP DOWN DOWN
BINARY SWITCH B UP DOWN UP DOWN
HANDSET (TRINARY) SWITCH DOWN UP MIDDLE MIDDLE
1 2 3 4 5 6 7 8
Binary Switch A
Step 1:
Fill out the below table using both of the 8 digit codes inside your control box. Identify if the switch is in
the ‘UP’ or ‘DOWN’ position.
1 2 3 4 5 6 7 8
Binary Switch B
Step 2:
Using the information collected in Step 1, use the ‘Binary to Trinary Conversion Table’ to determine
your new handset code. Please note, these numbers are not in sequence (eg the second digit in your
handset code is the result of the third digits from your control box code). The ninth digith is always in
the ‘DOWN’ position.
1 3 4 6 7 2 5 8 9
DOWN
Handset Code
Using your new ‘Handset Code’, follow the ‘Trinary Handset Coding’ instructions to
complete your Handset programming.
Table of contents
