Global Industrial DJ365 User manual

- 0 -
Instruction Manual
Drum Pallerizer
Note: The Owner/Operator must read carefully and understand
all the information presented here before operation.

- 1 -
THANK YOU FOR USING THIS DRUM PALLERIZER. FOR YOUR
SAFET AND CORRECT OPERATION, PLEASE CAREFULLY READ
THIS INSTRUCTION BEFORE USING IT.
NOTE: All of the information reported herein is based on data available
at the moment of printing. The factory reserves the right to modify its
own products at any moment without notice and incurring in any
sanction. So it is suggested to always verify possible updates.
1. SPECIFICATION
Model DJ365
Capacity 365kg / 800lbs
Acceptable Drum Style 55 gallon, steel
Overall Size L×W×H 1250*1100*1250 mm
Net Weight 60kg
Wheel (poly) Dia*Width D150*50, D100*32mm
2. NOTICE
2.1 Do not operate this pallerizer more than 70m/min speed when
overloading.
2.2 Do not operate the pallerizer unless you are trained and authorized.
2.3 Please operate the pallerizer on the hard surface.
2.4 Please push the drum when operating the pallerizer.
3. OPERATION
3.1 Clamp the pawl handle for putting the handle on the top position.
3.2 Push the drum near the pallet, the big hook button up the drum while
two small hooks button up the side of drum, then pull the handle until
the lowest position.
3.3 When release the drum, press the handle down, then clamp the pawl

- 2 -
handle and lower the handle slowly to put the drum on the ground.
4. EXPLODED VIEW & PART LIST
※
17
18
19
20
21

- 3 -
No. Description Qty Remark
1. Split pin 2 Ф3.2*32
2. Hook assembly 1
3. Pipe core 1
4. Handle assembly 1
5. Left columniation 1
6. Hex bolt 2 M12*80
7. Flat washer 4 Ф12
8. Hex nut 2 M12
9. Pneumatic columniation 1
10. Hex bolt 4 M10*70
11. Flat washer 8 Ф10
12. Hex nut 4 M10
13. Wheel 2 Ф150
14. Wheel shield 2
15. Hex nut 2 M12
16. Right columniation 1
※ Pawl handle 2
17. Pedestal 1
18. Swivel wheel 2 Ф100
19. Hex bolt 8 M10*20
20. Flat washer 8 Ф10
21. Spring washer 8 Ф10
NOTE: “※” had been contained in No 4 ( the hand assembly )