Global Industrial B264201 User manual

User's manual Manual del usuario Manuel de l'utilisateur
Customer Service
US: 1-800-645-2986
Servicio de atención al Cliente
US: 1-800-645-2986
Service à la clientèle
Canada: 888-645-2986
CONTENTS
REF. QTY. REF. QTY.DESCRIPTION
Bench
Ends 2
Hex Head Bolts
1-1/2" Long
Screws
1-1/4" Long
Screws
Concrete Anchors
4
4
36
4
Support
Rods 2
Bullnose Slats
2
Back
& Seat
Brace
2Seat & Back
Slats 7
Before you begin: Check components to verify all are included. Assembly will require two people and must be
performed on a level and smooth surface. Do not overtighten hardware as damage can occur.
Tools for assembly: Powered Driver , Phillips head bit,
Ratchet Wrench, 11/16" Socket.
Step 1
Loosely attach support rods to side frames using hex
head bolts. See illustration "A".
Step 2
Place the seat & back braces equally spaced on the cross
support rods, see illustration "B". Note - it is necessary for
a second person to assist with this step as braces will not
stand up on their own.
1
Models:
B264201: Cedar
B264298: Gray
B264197: Green
6' Recycled Plastic Heritage Bench

Plastic Heritage Bench
2
User's Manual
Step 3a
Position the front bullnose seat slat with the rounded edge
facing out in the slots of each bench end. See illustration
"C".
Step 3b
Continue inserting the seat slats in the bench ends. See
illustration "D".
Step 3c
Insert the back slats, the final top slat will be the bullnose with the
rounded edge facing up. With all slats in place, tighten the hex head
bolts each bench end previously installed. See illustration "E".
Step 4
Attach the back & seat braces to the backside of the slats using
1-1/4" screws at the pre-drilled holes or slots of the braces.
Secure the bench ends to the upper and lower bullnose slats
with the 1-1/2" screws through the pre-drilled holes of the sides
frames. See illustration "F".
The assembled bench can be securely fastened to a solid
surface using the included wedge anchors for concrete or other
approprate hardware.