Global 695528 User manual

Before you begin: Check components to verify all are included. Assembly requires two people and must be performed on a flat and
even surface. Do not overtighten hardware as damage can occur.
Step 1
Step 2
As of 10/2019
Page 1 of 2
Position the table supports upright and parallel to each other on a
flat surface. Lay a seat slat across the mounting surface of each support
with the angle brace (mounted under seat) facing down. Attach
using 2 1/4" long carriage bolts, lock washers and hex nuts.
Repeat for the other side.
Attach one outside edge table top slat to the supports using
2 1/4” long carriage bolts, lock washers and hex nuts. Place middle table
strut with flat side facing up and perpendicular to the underneath side of
previously installed table top board, attach using 2 1/4” long carriage bolt,
lock washer and hex nut.
CONTENTS
Ref. Qty. Description
1 2 Table
Supports
2 2 Arm Struts
3 3 Table Top
Slats
Ref. Qty. Description
4 1 Middle
Table Strut
5 2 Seat Slats
H1 1 Hardware
Pack
72” Recycled Plastic Picnic Table
Assembly Instructions
Assembly Instructions
Customer Service
US: 1-800-645-2986
Model #s: 695528, 695550, 695551

Step 3
Step 4
As of 10/2019
Page 2 of 2
Attach center table top slat to supports using 2 1/4” long carriage
bolts, lock washers and hex nuts. Position both arm struts on
the middle table strut, attach to strut and middle slat using a 3”
long carriage bolt, flat washer, lock washer and hex nut, leave
loosely tightened. Attach both support arms to lower table support
lbracket using 1” hex bolt, flat washer, lock washer, and hex nut.
Connection Detail
Attach the remaining table top slat to the supports and middle
strut using 2 1/4” long carriage bolts, lock washers and hex nuts.
All hardware can now be tightened.